- ページ 15
冷蔵庫 Whirlpool 3VED23DQのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 3VED23DQ 25 ページ。 No-frost refrigerator-freezers with thirst crusher
Whirlpool 3VED23DQ にも： 取扱説明書 (30 ページ)
ページを印刷する
Solving
common
ice maker
problems
PROBLEM
CAUSE
SOLUTIONS
Ice dispenser
l
Freezer door open
l
Close the freezer door.
won't work
l
Ice bin not properly installed
l
Make sure bin is pushed in all the way.
9 Wrong ice in bin
0 Use only crescents
from ice maker. Shake
the bin occasionally
to keep cubes separated
and to obtain increased storage capacity.
l
Dispenser not used for
l
Dump old ice and make a new supply.
extended periods, causing
ice cubes to melt together
Ice dispenser
l
Ice dispenser bar held in
l
Wait about 3 minutes for the dispenser motor
stops working
too long
to reset.
l
Large amounts of ice should be taken from the
bin, not through
the dispenser.
Off-taste
or
odor in ice
l
Ice attracts airborne odors;
l
Dump old ice and make a new supply. Store
old ice
excess ice in covered container.
l
Water quality
l
Water containing minerals (such as sulfur) may
require a filter to remove.
l
Foods not properly wrapped
l
Wrap properly. See pages 20 and 21.
l
Ice bin and freezer may
l
Clean freezer and ice bin. See cleaning chart
need cleaning
on page 18.
l
Plumbing to ice maker
l
Follow Installation Instructions for proper ice
maker water supply hook up. (See back of
refrigerator cabinet.)
l
New ice maker
l
The first few loads of ice from a new ice maker
may have an off-taste. Dump ice and make a
new supply.
Removing
the door
trim
(dispenser
area)
(3VED29DQ
only)
To remove the trim:
1.
Remove
all items
from the shelf.
2.
Pull trim piece straight up at each end.
To replace the trim:
1. Locate each end of trim piece above the
trim pocket opening in refrigerator door
liner.
2. Push the trim piece straight down until it
stops.
3. Replace items on the shelf.
15