- ページ 14

ドライヤー Ariston TCL73XのPDF 使用および設置マニュアルをオンラインで閲覧またはダウンロードできます。Ariston TCL73X 44 ページ。
Ariston TCL73X にも：お手入れ、使用および設置に関する小冊子 (44 ページ)

ページを印刷する

Installation Instructions

Read these instructions with care.

These instructions are provided for use by qualified

installers, in addition the installation must comply with:

In the United States, in accordance with the

National Electric Code ANSI/NFPA70 - latest edition

and any State, Municipal or local codes.

In Canada, in accordance with the Canadian

Electric Code C22.1 - latest edition and any

Provincial, Municipal or local codes.

Electrical

The dryer comes with a four-wire power supply cord

fitted with a 14-30P (plug), a receptacle should be

fitted in a location accessible after the dryer is

installed. The four wire dryer wire cord assembly fitted

must be used when the appliance is installed in a

location where grounding through the neutral is

prohibited. Grounding through the neutral is prohibited

for; new branch-circuit installations; mobile homes,

recreational vehicles and areas were local codes do

not allow grounding through the neutral conductor.

If a 10-30R (receptacle) is installed a locally obtained

3 wire dryer cord kit minimum ratings 240V, 30A, 95C

and marked for clothes dryers (ring terminals) should

be fitted

To fit a 10-30P dryer cord assembly follow the steps

below:

1. Make sure the dryer is not plugged into a power

outlet.

2. Remove the cover from the cable junction box

located on the rear of the dryer.

3. Remove Green link wire from ground terminal.

4. Loosen the nut securing the cable bush, disconnect

and discard the existing cable and bush.

5. Fit one end of the Green link to the ground terminal

using washer and nut. Position the link wire to the

Neutral terminal (N), but do not fit securing screw at

this stage.

6. Follow any instructions provided with the kit and fit

the cable using the strain relief supplied with the

kit, do not fully tighten the strain relief at this stage.

Green link wire.

7. Connect the L1, N and L2

wires.

On flat cords the center wire

is the Neutral conductor, fit to

the terminal marked 'N'.

On round cords the Green or

White conductor should be

fitted to the terminal marked 'N'.

8. Fully tighten the terminal block screws and ground

connection nut, position the cord, finally fully tighten

the strain relief.

9. Refit the cover to the box.

Grounding

Some local codes may require a separate ground. In

such cases the required ground wire, clamp and

screw must be purchased separately.

NEVER ground the dryer to plastic plumbing lines,

gas lines or water pipes.

NOTE: IF IN DOUBT ABOUT ANY OF THE ABOVE

CONSULT A QUALIFIED ELECTRICIAN.

Where to put your dryer

Check local codes before choosing a location. Some

codes do not permit installation in a garage, closet,

mobile home or bedroom.

DO NOT install the dryer in an area where gasoline or

other inflammable materials are kept or stored.

When operating the dryer, there has to be adequate

ventilation. Make sure you put the dryer in an

environment that is not damp and has proper air

circulation throughout. Airflow around the dryer is

essential to condense the water produced during

washing, the dryer will not operate sufficiently in an

enclosed space or cupboard. If installed in a closet

we recommend that you leave the door open when

the dryer is in use.

! If using the dryer in a small room or cold room some

condensation could be experienced.