ページを印刷する1. LAYOUT POLES TOGETHER ON FLOOR AND ASSEMBLE TO SWIVEL PLATES WITH
FASTENERS AS SHOWN
2. SCREW IN THE PROPER SCREWS INTO PLATE DO NOT OVERTIGHTEN.
3. WHILE HOLDING THE SCREW IN PLACE START TO THREAD THE NYLOCK NUT ONTO
THE SCREW AND TIGHTEN BY HAND UNTIL RESISTANCE IS FELT. THEN USING 7/16 SOCKET
OR WRENCH CONTINUE TO TIGHTEN NUT UNTIL IT IS EVEN WITH END OF SCREW. DO NOT
OVERTIGHTEN.
STEP-5
SLIDE CLIP ONTO POLE AND SNAP INTO THE TWO HOLES
LOCATED ON THE HOOP BEFORE ADDING FASTENERS.
INTO
DO NOT USE NUT
WITH THIS SCREW.
POLES SHOULD MOVE
EASILY, DO NOT OVERTIGHTEN