ページを印刷する
1. SLIDE HOOP POLES OVER
TUBE EXTENSIONS AND LOCK
INTO PLACE WITH COLLARS.
COMPLETED HOOP POLE ASSEMBLY AT THIS POINT SHOULD MOVE
FREELY AND LOOK LIKE THE FOLLOWING PICTURE.
WIRE FROM LIGHT STICK SHOULD BE LOCATED ON SAME SIDE
AS BATTERY HOLDER
DO NOT INSTALL FRONT
HOOP POLE AT THIS TIME
2. ATTACH THE EXTENSION POLES TO THE
HINGE CLIP ASSEMBLY WITH FASTENERS
INCLUDED WITH CLIP ASSEMBLY AS SHOWN.
BATTERY
BRACKET
HOLDER.
STEP-7
HINGED POLE MUST ROTATE
FREELY ONCE TIGHTENED.
cLIP
INSTALL ROPE
AND TIE OFF ENDS
INSIDE OF BASE.