- ページ 2

自動車アクセサリー Clam RUNNER KITのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Clam RUNNER KIT 2 ページ。 For: x200 / x400
Clam RUNNER KIT にも：クイック・スタート・マニュアル (2 ページ), クイック・スタート・マニュアル (2 ページ)

QTY.

PART NO.

103405

103424

101550

102516

101548

101549

For: Kenai, Scout Xl and Legend XL Thermal models, CUT THE RUNNERS TO 39" in length.

For: Kodiak, Denali, X1, Nordic Med Sled and Warrior models, NO CUTTING IS REQUIRED.

1. Position the strips on the base. Using a 3/16" or slightly larger drill bit, drill a hole through runner strip

and base starting at the curved end of the base.

2. Slightly tighten fasteners to hold the strip in place so that you may then bend the runner around the

curved area before drilling the next hole

(If you have trouble bending the Wear Strip to the contour of the base, use a heat gun or hair dryer to

make the Strips more pliable before drilling.)

( Also, apply a small amount of grease to threads of screw to prevent seizing of threads.)

Drill next hole through the runner strip and base and slightly tighten fastener to hold the runner in

place.

4. Keep repeating this procedure EVENLY SPACING for remaining holes and securely tighten all

fasteners when they are all installed.

5 . Repeat same process for remaining runners.

START HERE

Kodiak, Denali, Warrior

PARTS LIST

DESCRIPTION

RUNNER, SML, 41" LG

INSTRUCTION, RUNNER KIT

KIT, HARDWARE RUNNER

SCREW,10-24 X 1" PTHMSSS

NUT, 10-24 NYLOCK SS

WASHER, #10 FENDER SS

Runner Kit Installation

39"

41"

(includes the following)

KENAI / SCOUT XL / LEGEND XL THERMAL

KODIAK / DENALI / X1 / NORDIC MED SLED /

WARRIOR

START HERE

Kenai