- ページ 13

ドライヤー Whirlpool WED7500VWのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WED7500VW 20 ページ。 Compact electric dryer with 11 cycles
Whirlpool WED7500VW にも：仕様 (8 ページ), 取扱説明書 (20 ページ), 寸法と設置について (1 ページ), 取扱説明書 (8 ページ), インストレーション・インストラクション (2 ページ)

Level Dryer

Check the levelness of the dryer. Check levelness first

side to side, then front to back.

If the dryer is not level, prop up the dryer using a wood block.

Use a wrench to adjust the legs up or down and check again for

levelness.

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check the dryer's final location. Be sure the vent is not

crushed or kinked.

5. Check that the dryer is level. See "Level Dryer."

6. Plug into a grounded outlet. Turn on power.

7. Remove the clear protective film on the front edge and any

tape remaining on the dryer.

8. Read "Dryer Use."

9. Wipe the dryer drum interior thoroughly with a damp cloth to

remove any dust.

10. Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

If the dryer will not start, check the following:

Controls are set in a running or "On" position.

Start button has been pushed firmly.

Dryer is plugged into a grounded outlet and/or electrical

supply is connected.

Household fuse is intact and tight, or circuit breaker has

not tripped.

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close the door.

If you do not feel heat, turn off the dryer and check the

following:

There may be 2 household fuses or circuit breakers for the

dryer. Make sure both fuses are intact and tight, or that both

circuit breakers have not tripped. If there is still no heat,

contact a qualified technician.

NOTE: You may notice a burning odor when the dryer is first

heated. This odor is common when the heating element is first

used. The odor will go away.