- ページ 10
ドライヤー Whirlpool WED9051YWのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WED9051YW 20 ページ。 Installation guide
Whirlpool WED9051YW にも： 取扱説明書 (20 ページ)
ページを印刷する3.
Connect ground wire
A
F
Connect ground wire (F) (green or bare) of power supply cord
to external ground conductor screw (A). Tighten screw.
4.
Connect remaining wires
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover
into slot of dryer rear panel. Secure cover with hold-down
screw. Now, go to "Venting Requirements."
3-WIRE POWER SUPPLY CORD
CONNECTION
Use where local codes permit connecting
cabinet-ground conductor to neutral wire.
3-wire receptacle (NEMA
type 10-30R)
Spade terminals with
upturned ends
10
3-prong plug
Ring terminals
1.
Remove center screw
Remove center terminal block screw (B).
2.
Connect neutral wire
Connect neutral wire (white or center) (C) of power supply cord
to center terminal block screw (B). Tighten screw.
3.
Connect remaining wires
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover
into slot of dryer rear panel. Secure cover with hold-down
screw. Now, go to "Venting Requirements."
B
B
C