- ページ 15

ドライヤー Whirlpool 240-VOLT ELECTRIC DRYERのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 240-VOLT ELECTRIC DRYER 24 ページ。 240-volt electric dryer
Whirlpool 240-VOLT ELECTRIC DRYER にも：取扱説明書 (20 ページ), 取扱説明書 (33 ページ), 取扱説明書 (24 ページ), 取扱説明書 (32 ページ)

ページを印刷する

Connect Vent

1. Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in

dryer. If connecting to existing vent, make sure the vent is

clean. The dryer vent must fit over the dryer exhaust outlet

and inside the exhaust hood. Make sure the vent is secured

to exhaust hood with a 4" (10.2 cm) clamp.

2. Move dryer into its final position. Do not crush or kink vent.

3. (On gas models) Check to be sure there are no kinks in the

flexible gas line.

4. Once the exhaust vent connection is made, remove the

corner posts and cardboard.

Level Dryer

Check levelness of dryer. Check levelness first side to side, then

front to back.

If dryer is not level, prop the dryer up using a wood block. Use a

wrench to adjust the legs up or down and check again for

levelness.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check the dryer's final location. Be sure the vent is not

crushed or kinked.

5. Check that the dryer is on a level surface.

6. For power supply cord installation, plug into an outlet. For

direct wire installation, turn on power.

7. Remove the blue protective film on the console and any tape

remaining on the dryer. Remove tape from the lint screen

(located on inside back wall of dryer).

8. Read "Dryer Use."

9. Wipe the dryer drum interior thoroughly with a damp cloth to

remove any dust.

10. To test the dryer, set the dryer on a full heat cycle (not an air

cycle) for 20 minutes and start the dryer.

If the dryer will not start, check the following:

Controls are set in a running or "On" position.

Push to Start button has been firmly pressed.

Dryer is plugged into an outlet and/or electrical supply

is on.

Household fuse is intact and tight, or circuit breaker has

not tripped.

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close the door.

If you do not feel heat, check the following:

Controls are set on a heated cycle, not an air cycle.

NOTE: You may notice a burning odor when dryer is first heated.

This odor is common when the heating element is first used. The

odor will go away.