- ページ 16

ドライヤー Whirlpool 27" W10563341AのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 27" W10563341A 20 ページ。 Electric dryer 27" wide models

ページを印刷する

1. Troubleshooting

COMPLETE INSTALLATION

CHECKLIST

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

Check that you have all of your tools.

Dispose of/recycle all packaging materials.

Check dryer's final location. Be sure vent is not crushed

or kinked.

Check that dryer is level. See "Level Dryer".

Remove film on console and any tape remaining on dryer.

Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

Read "Dryer Use" in your "Use and Care Guide."

Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

If the dryer will not start, check the following:

Controls are set in a running or "On" position.

■

Start button has been pushed firmly.

■

Dryer is plugged into an outlet and/or electrical supply

■

is on.

Household fuse is intact and tight, or circuit breaker has

■

not tripped.

Dryer door is closed.

■

When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close the door.

If you do not feel heat, turn off dryer, and check the

following:

There may be 2 household fuses or circuit breakers for

■

the dryer. Check that both fuses are intact and tight, or

that both circuit breakers have not tripped. If there is still

no heat, contact a qualified technician.

NOTE: You may notice an odor when the dryer is first heated.

This odor is common when the heating element is first used.

The odor will go away.

REVERSE DOOR SWING

(OPTIONAL)

If your door is the 27" Wide Side-Swing Door, go to steps 1–11

beginning on this page.

If your door is the 27" Wide Side-Swing Door with Glass, go to

steps 1–13 beginning on page 18.

NOTE: Magnetized screwdriver is helpful.

27" Wide Model Side-Swing Door

Place towel on dryer

Place towel on top of dryer to avoid damaging the surface.

Remove bottom screws

Open dryer door. Remove bottom screws from dryer cabinet

side of hinges. Loosen (do not remove) top screws from dryer

cabinet side of hinges.

Lift door off top screws

Lift door until top screws in dryer cabinet are in large part of

hinge slot. Pull door forward off screws. Set door (handle side

up) on top of dryer. Remove top screws from dryer cabinet.