- ページ 7

ドライヤー Whirlpool 27'のPDF ジョブエイドをオンラインで閲覧またはダウンロードできます。Whirlpool 27' 36 ページ。 Microwave oven and thermal oven
Whirlpool 27' にも：取付説明書 (11 ページ), 取付説明書 (11 ページ), 取付説明書 (48 ページ), 取付説明書 (22 ページ), 取付説明書 (27 ページ), 取付説明書 (32 ページ), 取付説明書 (12 ページ), インストレーション・インストラクション (5 ページ)

Electrical Requirements for Electric Dryers

Important: Observe all governing codes and ordinances.

Check with a qualified electrician if you are in doubt as to whether the appliance

is properly grounded. Do Not modify the power supply cord plug. If it will not fit

the outlet, have a proper outlet installed by a qualified electrician.

Improper connection of the equipment-grounding conductor can result in a risk

of electrical shock.

Do Not have a fuse in the neutral or grounding circuit. This could result in a risk

of electrical shock.

Do Not plug the power supply cord (pigtail) into any receptacle before connecting

the pigtail to the dryer terminal block. This could result in a risk of electrical

shock.

A. A three-wire (Fig. 2) or four-wire (Fig. 3),

single phase, 120/240 volt, 60 Hz, AC only

electrical supply is required on a separate

30-ampere circuit, fused on both sides of

the line. A time-delay fuse or circuit

breaker is recommended.

B. Most local codes permit the use of flexible,

30-amp rated, power supply cord (pigtail).

The power cord must be plugged into a

mating 30-amp receptacle (NEMA type

10-30R). A U.L.- listed strain relief must

be installed where the power cord enters

the dryer.

C. THE DRYER MUST BE CONNECTED

WITH 10-GAUGE MINIMUM COPPER

WIRE ONLY. Do Not use aluminum wire

which could cause a fire.

D. The power supply cord (pigtail) can be

removed and the appliance can be con-

nected directly to an individual 30-ampere

fuse circuit breaker box through flexible

armored or nonmetallic sheathed, 10-

gauge minimum copper cable. It is the

personal responsibility and obligation of

Electrical ground is required on this product.

WARNING

Electrical Shock Hazard

Fig. 2

Fig. 3