- ページ 6

ドライヤー Whirlpool 27'のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 27' 32 ページ。 Microwave oven and thermal oven
Whirlpool 27' にも：ジョブエイド (36 ページ), 取付説明書 (11 ページ), 取付説明書 (11 ページ), 取付説明書 (48 ページ), 取付説明書 (22 ページ), 取付説明書 (27 ページ), 取付説明書 (12 ページ), インストレーション・インストラクション (5 ページ)

ページを印刷する

Prepare Built-In Oven

1. Decide on the final location for the oven. Avoid drilling or

cutting into house wiring during installation.

WARNING

Excessive Weight Hazard

Use two or more people to move and install oven.

Failure to do so can result in back or other injury.

2. To avoid floor damage, set the oven onto cardboard prior to

installation. Do not use handle or any portion of the front

frame for lifting.

3. Remove the shipping materials and tape from the oven.

Remember to keep the corner posts and other materials that

may be needed for installation. Remember to remove bottom

vent and bottom vent trim from foam packing on top of oven

4. Remove the hardware package from inside the bag

containing literature.

5. Remove and set aside racks and other parts from inside the

oven.

6. Verify foam strip is attached to the back of the control panel

as shown in the following picture below. If the foam strip is

not present, please reference the "Assistance or Service"

section of the Use and Care Guide or contact the dealer from

whom you purchased your built-in oven to order Part Number

W10489273.

NOTE: Once the oven is installed in the cabinet, make sure

the foam strip is positioned against the cabinet face.

A. Foam strip

7. Move oven and cardboard close to the oven's final location.

Remove Oven Door(s)

IMPORTANT: Use two hands to remove oven door. For double

ovens, repeat the process for each door.

1. Prior to removing the oven door, prepare a surface where you

will place it. This surface should be flat and covered with a

soft blanket, or use the corner posts from your packaging

material.

2. Open the oven door.

INSTALLATION INSTRUCTIONS

3. Locate the oven door hinge locks in both corners of the oven

door, and rotate the hinge locks toward the oven door to the

unlocked position. If the door hinge lock is not rotated fully

(see illustration B), the door will not remove properly.

A. Oven door hinge lock in

locked position

4. Partially close the door to engage the door latch locks. The

door will stop at this point.

5. Using two hands, grasp the edges of the oven door. Lift and

pull the oven door toward you and remove. You may need to

gently shift door from side to side as you pull.

6. Set the oven door(s) aside on the prepared covered work

surface, with the oven door resting on its handle.

7. To continue with the oven installation, go to the "Positioning

Oven Feet for Multiple Cabinet Cutout Heights" section.

B. Oven door hinge lock in

unlocked position