- ページ 5

ドライヤー Whirlpool 29 (73.)のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 29 (73.) 12 ページ。 29 in. (73.7 cm) electric dryer

ページを印刷する

1. Tools and Parts

Electrical Connection Options

If your home has:

And you will be

connecting to:

4-wire receptacle

A UL listed, 120/

(NEMA Type 14-30R)

240 volt

minimum, 30

amp., dryer

power supply

cord*

4-wire direct

A fused

disconnect or

circuit breaker

box*

(12.7 cm)

3-wire receptacle

A UL listed, 120/

(NEMA type 10-30R)

240 volt

minimum, 30

amp., dryer

power supply

cord*

3-wire direct

A fused

disconnect or

circuit breaker

box*

* If local codes do not permit the connection of a frame-

grounding conductor to the neutral wire, go to "Optional 3-wire

connection" section.

4-wire connection: Power Supply Cord

IMPORTANT: A 4-wire connection is required for mobile homes

and where local codes do not permit the use of 3-wire

connections.

1. 4-wire receptacle (NEMA type 14-30R)

2. 4-prong plug

3. Ground prong

4. Neutral prong

5. Spade terminals with upturned ends

6. ¾ in. (1.9 cm) UL approved strain relief

7. Ring terminals

Go to Section

4-wire connection:

Power Supply

Cord

4-wire connection:

Direct Wire

3-wire connection:

Power Supply

Cord

3-wire connection:

Direct Wire

1. Remove center terminal block screw.

2. Remove appliance ground wire (green with yellow stripes)

from external ground connector screw. Fasten it under center,

silver colored terminal block screw.

1. External ground connector - Dotted line shows

position of NEUTRAL ground wire before being

moved to center terminal block screw

2. Center silver-colored terminal block screw

3. Green/yellow wire of harness

3. Connect ground wire (green or bare) of power supply cord to

external ground conductor screw. Tighten screw.

4. Connect neutral wire (white or center wire) of power supply

cord under center screw of the terminal block.

in. (1.9 cm) UL-listed strain relief

2. Green wire of power supply cord or bare copper wire

3. External ground connector

4. Center silver-colored terminal block screw

5. Neutral wire (white or center wire)

6. Neutral grounding wire (green/yellow)

5. Connect the other wires to outer terminal block screws.

Tighten screws.

6. Tighten strain relief screws.

7. Insert tab of terminal block cover into slot of dryer rear panel.

Secure cover with hold-down screw.