- ページ 7

ドライヤー Whirlpool 3LWED4900YWのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool 3LWED4900YW 30 ページ。

For Both Gas and Electric Dryers:

NOTE: In accordance with the European EMC Directive

(89/336/EEC) the maximum electricity supply system impedance

to which the electric dryer should be connected is declared to be

0.29 Ohm + J0.18 Ohm.

This dryer has a Maximum power absorption/usage of 4700 watts.

If code permits and an additional earth bond wire is used, it is

recommended that certi ed electrician determine that the earth

bond path is adequate.

Electrical Safety Standards: The manufacturer has chosen

compliance with IEC/EN.60335 standards as the most

appropriate for this product.

Do not use an adapter.

Recommended Earthing Method

It is your responsibility to contact a quali ed electrical installer

to ensure that the electrical installation is adequate and in

conformance with all local codes and ordinances.

GAS REQUIREMENTS

OBSERVE ALL GOVERNING CODES AND ORDINANCES.

Gas supply:

Check that dryer is equipped with the correct burner for the

particular type of gas supply. Burner information will be found

on the model/serial rating plate in the door well of the dryer. If

this information does not agree with the type of gas available,

see your dealer.

Natural Gas:

This dryer is factory adjusted for use with NATURAL GAS (G20),

and no further adjustment should be required at installation.

L.P. Gas:

This dryer is also certi ed for use with L.P. (propane or butane)

gases with appropriate conversion. No attempt shall be made to

convert the appliance from the gas speci ed on the model/serial

rating plate for use with a different gas without consulting the

serving gas supplier.

Conversion must be done by a quali ed service technician.

Gas conversion kits are available for purchase from your dealer.

Full instructions are supplied with the kit.

Supply Line Requirements

Provide a rigid gas supply line to the dryer location. It should be

minimum 12.5 mm (1/2") ID. When acceptable to the gas supplier

and local codes, 10 mm (3/8") ID rigid supply line may be used

for lengths under 6.1 m (20'). Pipe-joint compounds resistant to

the action of L.P. gas must be used.