- ページ 8

ドライヤー Whirlpool 3RLEQ8033のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 3RLEQ8033 8 ページ。 Electric and gas dryers
Whirlpool 3RLEQ8033 にも：取扱説明書 (12 ページ), 取付説明書 (8 ページ), 取付説明書 (8 ページ), 取扱説明書 (12 ページ)

ページを印刷する

Connect Vent

1. Connect vent to dryer outlet using 102 mm (4") clamp. If

connecting to existing vent, make sure the vent is clean. The

vent must t over the dryer outlet and inside the exhaust hood.

2. Move dryer into nal position. Do not crush or kink exhaust

vent. Make sure dryer is level.

Reverse Door Swing (Optional)

You can change your door swing from a right-side opening to a

left-side opening, if desired.

1. Place towel (A) on top of dryer to protect surface.

2. Open dryer door. Remove bottom screws from cabinet side of

hinges (B). Loosen (do not remove) top screws from cabinet

side of hinges.

3. Lift door until top screws in cabinet are in large part of hinge

slot. Pull door forward off screws. Set door (handle side up) on

top of dryer. Remove top screws from cabinet.

4. Remove screws attaching hinges to door.

5. Remove screws at top, bottom, and side of door (5 screws).

Holding door over towel on dryer, grasp sides of outer door

and gently lift to separate it from inner door. Do not pry apart

with putty knife. Do not pull on door seal or plastic door catch.

6. Be certain to keep cardboard spacer centered between doors.

Reattach outer door panel to inner door panel so handle is on

the side where hinges were just removed.

W10115523B

2009 Whirlpool Corporation.

Registered Trademark/TM Trademark of Whirlpool, U.S.A.

7. Attach door hinges to dryer door so that the larger hole is at

the bottom of the hinge.

8. Attach plugs to right side using the same 4 screws.

9. Insert screws into bottom holes on left side of cabinet. Tighten

screws halfway. Position door so large end of door hinge slot

is over screws. Slide door up so screws are in bottom of slot.

Tighten screws. Insert and tighten top screws in hinges.

10. Close door and check that door strike aligns with door catch.

If it is needed, slide door catch left or right within slot to

adjust alignment. Remove the 4 screws that attach 2 plugs

on the left side.

Complete Installation

1. Check to be sure all parts are now installed. If there is an

extra part, go back through the steps to see which step was

skipped.

2. Check to be sure you have all of your tools.

3. Properly dispose of all packaging materials.

4. Check the dryer's final location. Be sure the vent is not

crushed or kinked.

5. Check to be sure the dryer is level. See "Level the Dryer."

6. Read the Use & Care Guide to fully understand your new

dryer.

7. Select a full heat cycle (not the air cycle) and start dryer. After

five minutes, open dryer door. You should feel heat inside the

dryer or on the exhaust vent. If dryer makes an unusual noise,

check that the dryer is level.

Technical Specifications

(see rating plate in door opening for full model details)

220-240V ~ 50 Hz, 1 ph

4575W, IP24

Clothes capacity: 9.0 Kg max.

6/09

Printed in U.S.A.