- ページ 11

ドライヤー Whirlpool 3XWED5705のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 3XWED5705 40 ページ。 Electric and gas dryer
Whirlpool 3XWED5705 にも：取扱説明書 (36 ページ)

ページを印刷する

Regular Servicing

To keep your dryer operating at highest ef

servicing by a designated Whirlpool service technician is

recommended. For normal use, this servicing should be at

12-month intervals. For heavy-duty usage, this interval should

be reduced accordingly.

Vacation and Moving Care

Vacation care

Operate your dryer only when you are at home. If you will be on

vacation or not using your dryer for an extended period of time,

you should:

1. Unplug dryer or disconnect power.

2. If you have a gas dryer, close shutoff valve in gas supply line.

3. Clean lint screen. See "Cleaning the Lint Screen."

First try the solutions suggested here and possibly avoid the cost of a service call...

Dryer Operation

Dryer will not run

Has a household fuse blown, or has a circuit breaker

tripped?

Check that the fuse is intact and tight, or that the circuit

breaker has not tripped. Replace the fuse or reset the circuit

breaker. If the problem continues, call an electrician.

Is the correct power supply available?

Electric dryers require 220-240-volt power supply. Check with

a quali ed electrician.

Was a regular fuse used?

Use a time-delay fuse.

Is the dryer door rmly closed?

Was the Start button rmly pressed?

No heat

For gas dryers, is the valve open on the supply line?

Unusual sounds

Has the dryer had a period of non-use?

If the dryer hasn't been used for a while, there may be a

thumping sound during the rst few minutes of operation.

Is a coin, button, or paper clip caught between the drum

and front or rear of the dryer?

Check the front and rear edges of the drum for small objects.

Clean out pockets before laundering.

Is it a gas dryer?

The gas valve clicking is a normal operating sound.

Are the four legs installed, and is the dryer level front to

back and side to side?

The dryer may vibrate if not properly installed. See the

Installation Instructions.

Is the clothing knotted or balled up?

When balled up, the load will bounce, causing the dryer to

vibrate. Separate the load items and restart the dryer.

Moving care - Electric Dryers

ncy, regular

1. Unplug the power supply cord.

2. Make sure leveling legs are secure in dryer base.

3. Use masking tape to secure dryer door.

Moving care - Gas Dryers

1. Unplug the power supply cord.

2. Close shutoff valve in gas supply line.

3. Disconnect gas supply line pipe and remove

4. Cap the open fuel supply line.

5. Make sure leveling legs are secure in dryer base.

6. Use masking tape to secure dryer door.

TROUBLESHOOTING

Clothes are not drying satisfactorily, drying times are too long,

or load is too hot

to dryer pipe.

Dryer Results

Is the lint screen clogged with lint?

Lint screen should be cleaned before each load.

WARNING

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in death

Is the exhaust vent or outside exhaust hood clogged with

lint, restricting air movement?

Run the dryer for 5-10 minutes. Hold your hand under the

outside exhaust hood to check air movement. If you do not

feel air movement, clean exhaust system of lint or replace

exhaust vent with heavy metal or exible metal vent. See the

Installation Instructions.

Are fabric softener sheets blocking the grille?

Use only one fabric softener sheet, and use it only once.

Is the exhaust vent the correct length?

Check that the exhaust vent is not too long or has too many

turns. Long venting will increase drying times. See the

Installation Instructions.

Is the exhaust vent diameter the correct size?

Use 102 mm (4") diameter vent material.

ings attached