- ページ 8
ドライヤー Whirlpool 3XWGD5705のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 3XWGD5705 40 ページ。 Electric and gas dryer
Whirlpool 3XWGD5705 にも： 取扱説明書 (36 ページ), 取付説明書 (36 ページ)
ページを印刷する3. Turn the Cycle Control knob to the recommended cycle for the
type of load being dried. See "Drying, Cycle, and Temperature
Tips."
4. Select a temperature setting on models with a Temperature
selector. The cycle descriptions include temperature setting
suggestions.
NOTE: The temperature selector is part of the Cycle Control
knob on some models.
5. Select the End of Cycle Signal, if available. The signal is
helpful when drying permanent press or synthetics. Promptly
remove these items from the dryer at the end of the cycle to
help avoid wrinkles.
6. Press PUSH TO START. Your gas dryer has an electronic
ignition system for the burner which is fully automatic; no
action is needed by the user (there is no pilot light).
NOTE: Your dryer stops automatically when a cycle ends.
Stopping and Restarting
You can stop your dryer anytime during a cycle.
To stop your dryer
Open the dryer door or turn the Cycle Control knob to OFF.
NOTE: The Cycle Control knob should point to an Off area when
the dryer is not in use.
To restart your dryer
1. Close the door.
2. Select a new cycle and temperature (if desired).
3. Press the Start button.
Drying, Cycle, and Temperature Tips
Select the correct cycle and temperature for your load.
Cool Down tumbles the load without heat during the last few
minutes of all cycles to make the load easier to handle.
Drying tips
Follow care label directions when they are available.
If desired, add a fabric softener sheet. Follow package
instructions.
Remove the load from the dryer as soon as tumbling stops, to
reduce wrinkling. This is especially important for permanent
press, knits, and synthetic fabrics.
Cycle and temperature tips
Use a High heat setting for drying heavyweight items such as
towels, work clothes, and sheets.
Use a Low heat setting for drying lightweight items such as
lingerie, underwear, blouses, dresses, permanent press
fabrics, and some knits.
Use an Air Dry (no heat) setting for rubber, plastic, or heat-
sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures for
various loads, refer to the care label directions. If you are unsure
of the temperature to select for a load, select a lower setting
rather than a higher setting.
8
Dryer Symbols
The control panel of your dryer contains symbols. Refer to the
chart below for a
nition of those symbols.
S
y
m
b
o
s l
Cool Down
TUMBLE PRESS
Cycle
D
a
m
p
D
y r
Wrinkle Shield
Timed Drying
D
e
c i l
t a
s e
Quick Dry
Synthetics/
Permanent Press
C
t o
o t
n
H
e
a
y v
Cycle Descriptions
This manual covers several different models. Your dryer may vary
from the model shown and may not have all of the cycles and
features described.
Cycle Control knob
Auto Dry cycle
Use your Automatic cycle to dry most loads. Your dryer has a
control that senses the moisture level in the load and shuts off
when the load reaches the selected dryness.
S
y
m
b
o
s l
Low/Knits
Medium/
Permanent Press
H
g i
/ h
H
e
a
y v
Temperature
On
O
f f
Push to Start
Push to Start
A
r i
F
u l
f f
R
e
a
d
O
p
e
a r
o t
s r
Manual