- ページ 4

ドライヤー Whirlpool 3XWGD5705のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 3XWGD5705 36 ページ。 Electric and gas dryer
Whirlpool 3XWGD5705 にも：取扱説明書 (36 ページ), 取扱説明書 (40 ページ)

ページを印刷する

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

■

Flat-blade screwdriver

■

Phillips screwdriver

■

Adjustable wrench that opens to 25 mm (1")

■

25 mm (1") Hex-head socket wrench

■

Level

■

200 or 300 mm (8" or 10") pipe wrench

■

6.35 mm (

") socket wrench or 6.35 mm (

■

Utility knife

■

Vent clamps

■

Pipe-joint compound resistant to LP gas

■

Sealing compound gun and compound (for installing new

exhaust vent)

■

Tin snip

Parts supplied

Remove parts bag from dryer drum. Check that all parts were

included.

■

4 leveling legs

■

4 gas inlet pipe adapters

Parts needed

Check local codes and gas supplier, and read electrical, gas and

venting requirements before purchasing parts.

Gas supply line must have:

• Shutoff valve

Rigid gas supply line must be:

• Minimum 12.5 mm (

") ID pipe

Flexible gas supply hose must be:

• Minimum 10 mm (

") ID approved flexible hose

L.P. gas conversion:

Gas conversion kit, part number 279918, available for purchase

from your dealer. Full instructions are supplied with the kit.

Conversion must be made by a competent technician.

INSTALLATION REQUIREMENTS

") nut driver

Location Requirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as petrol,

away from dryer.

Place dryer at least 460 mm (18 inches) above the floor

for a garage installation.

Failure to do so can result in death, explosion, or fire.

IMPORTANT: Observe all governing codes and ordinances.

■

Check code requirements: Some codes limit or do not permit

installation of clothes dryers in garages, closets, or sleeping

quarters. Contact your local building inspector.

■

Make sure that lower edges of the cabinet, plus the back and

bottom sides of the dryer, are free of obstructions to permit

adequate clearance of air openings for combustion air. See

"Recessed Area and Closet Installation Instructions" for

minimum spacing requirements.

NOTE: The dryer must not be installed in an area where it will be

exposed to water and/or weather. If room temperature is below

7º C (45º F), automatic cycles may not shut off.

■

Maximum slope under entire dryer should not be more than

25 mm (1"). If slope is greater than 25 mm (1"), install

Extended Dryer Feet Kit, Part No. 279810. Clothes may not

tumble properly and automatic sensor cycles may not

operate correctly if dryer is not level. Floor must be able to

support dryer weight of 79.4 kg (175 lbs).