- ページ 11

ドライヤー Whirlpool 4KWED4900のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 4KWED4900 35 ページ。

ページを印刷する

TROUBLESHOOTING

Clothes are not drying

Lint screen clogged with lint.

Lint screen should be cleaned before each load.

satisfactorily,

drying

times are too long, or

The Fluff Air cycle has been

Select the right cycle for the types of garments being dried.

load is too hot

selected.

See "Fluff Air."

Load too large and heavy to dry

Separate the load to tumble freely.

quickly.

Exhaust vent or outside exhaust

Run the dryer for 5-10 minutes. Hold your hand under the

hood clogged with lint, restricting

outside exhaust hood to check air movement.

If you do not feel

air movement,

clean exhaust system of lint or replace exhaust

vent with heavy metal or flexible metal vent. See Installation

Instructions.

Fabric softener sheets blocking

Use only one fabric softener sheet, and use it only once.

the grille.

Exhaust vent the incorrect length.

Check that the exhaust vent is not too long or has too

many turns. Long venting will increase drying times. See

Installation Instructions.

Exhaust vent diameter is the

Use 102 mm (4") diameter vent material.

incorrect size.

Dryer located in a room with

Proper operation of dryer cycles requires temperatures

above

temperature

below 7°C (45°F).

7°C (45°F).

Dryer located in a closet.

Closet doors must have ventilation openings at the top and

bottom of the door. The front of the dryer requires a minimum

of 25 mm (1 ") of airspace, and, for most installations, the rear

of the dryer requires 127 mm (5"). See Installation Instructions.

Dryer will not run

Door not closed completely.

Make sure the dryer door is closed completely.

PUSH to START knob not pressed

Press and hold the PUSH to START knob until you hear the dryer

firmly or held long enough,

drum moving.

Household fuse is blown or circuit

Electric dryers use 2 household fuses or circuit breakers. The

breaker has tripped,

drum may be turning, but you may not have heat. Replace the

fuse or reset the circuit breaker. If the problem continues,

call

an electrician.

Incorrect power supply.

Electric dryers require 220-240V/60H

power supply.

Check with a qualified electrician.

Wrong type of fuse.

Use a time-delay fuse.

Unusual sounds

Dryer had a period of non-use.

If the dryer hasn't been used for awhile, there may be a

thumping sound during the first few minutes of operation.

A coin, button, or paper clip is

Check the front and rear edges of the drum for small objects.

caught between the drum and front

Clean out pockets before laundering.

or rear of the dryer.

The four legs are not installed, and

The dryer may vibrate if not properly installed.

the dryer is not level front to back

See Installation Instructions.

and side to side.

Clothing knotted or balled up.

When balled up, the load will bounce, causing the dryer to

vibrate. Separate the load items and restart the dryer.

No heat

Household fuse is blown or circuit

The drum may be turning, but you may not have heat. Electric

breaker has tripped,

dryers use 2 household fuses or circuit breakers. Replace the

fuse or reset the circuit breaker. If the problem continues,

call

an electrician,