- ページ 32

ドライヤー Whirlpool 7MWED2040のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 7MWED2040 44 ページ。 Electric/gas dryer
Whirlpool 7MWED2040 にも：取扱説明書 (32 ページ)

Power Supply Cord Connection

Power supply cord strain relief

Attach power supply cord strain relief

Remove the screws from a 3/4" (19 mm) UL listed strain relief

(UL marking on strain relief). Put the tabs of the two clamp

sections (C) into the hole (B) below the terminal block opening

so that one tab is pointing up (A) and the other is pointing

down (D), and hold in place. Tighten strain relief screws just

enough to hold the two clamp sections (C) together.

Attach power supply cord strain relief

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight fit with the

dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.

For 3-wire Power Supply Cord Connection, see page 31.

For 4-wire Power Supply Cord Connection, continue to

step 3.

IMPORTANT: A 4-wire connection is required for mobile

homes and where local codes do not permit the use of 3-wire

connections.

Prepare to connect neutral ground

wire and neutral wire

Remove center terminal block screw (B). Remove neutral

ground wire (E) from external ground conductor screw (A).

Connect neutral ground wire and

neutral wire

Connect neutral ground wire (E) and neutral wire (white or

center) (C) of power supply cord under center terminal block

screw (B). Tighten screw.

A. 4-wire receptacle (NEMA type 14-30R)

B. 4-prong plug

C. Ground prong

D. Neutral prong

E. Spade terminals with upturned ends

F. 3/4" (19 mm) UL listed strain relief

G. Ring terminals