- ページ 12

ドライヤー Whirlpool 8314840BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 8314840B 15 ページ。 Electronic electric and gas dryers

ページを印刷する

Changing the Drum Light

If your dryer has a drum light, the dryer light automatically turns

on inside the dryer drum when you open the door.

To change the drum light

1. Unplug dryer or disconnect power.

2. Open the dryer door. Locate the light bulb cover on the back

wall of the dryer. Remove the screw located in the lower right

corner of the cover. Remove the cover.

3. Turn bulb counterclockwise. Replace the bulb with a 10-watt

appliance bulb only. Replace the cover.

4. Plug in dryer or reconnect power.

Removing Accumulated Lint from Inside the

Dryer Cabinet

Lint should be removed every two years, or more often,

depending on dryer usage. Cleaning should be done by a

qualified person.

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid

the cost of a service call...

Message Codes

For error message "PF" (power failure), check the

following:

Is the dryer connected to the power supply?

Was the dryer connected to a power supply during

installation or a power failure?

Press START to resume operation or press PAUSE/CANCEL

to cancel the cycle.

Was the drying cycle interrupted by a power failure?

Press START to resume operation or press PAUSE/CANCEL

to cancel the cycle.

For error message "E1" or"E2" (service codes):

Service is required, call for service.

Clothes are not drying satisfactorily

Check the following:

Is the lint screen clogged with lint?

Is the exhaust vent or outside exhaust hood clogged with lint,

restricting air movement? Run the dryer for

5-10 minutes. Hold your hand under the outside exhaust

hood to check air movement. If you do not feel air movement,

clean exhaust system of lint or replace exhaust vent with a

heavy metal vent. See your Installation Instructions.

Is the exhaust vent crushed or kinked? Replace with a heavy

metal vent. See your Installation Instructions.

Has a fuse blown, or a circuit breaker tripped? Electric dryers

use 2 household fuses or breakers. The drum may be turning

but you may not have heat.

Has an air dry cycle been selected? Select the right cycle for

the types of garments being dried (see "Drying, Cycle and

Temperature Tips").

Is the automatic cycle ending early? The load may not be

contacting the electronic sensor strips, level the dryer.

For gas dryers, is the valve open on the supply line?

Are fabric softener sheets blocking the grill? Use only one

fabric softener sheet and only use it once.

Is the dryer located in a room with temperature below

45ºF (7ºC)?

Proper operation of dryer cycles requires temperatures above

45ºF (7ºC).

Was a cold rinse water used? Was the load very wet?

Expect longer drying times with items rinsed in cold water

and with items that hold moisture (cottons).

Is the load too large and heavy to dry quickly?

Separate the load to tumble freely.