- ページ 25

ドライヤー Whirlpool Cabrio WED8000DのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool Cabrio WED8000D 30 ページ。 Smart electronic dryer

ページを印刷する

Troubleshooting — Dryer Operation

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help.

If you experience

Dryer Results (cont.)

Odors (cont.)

Load too hot

Dryer Displaying Code Message or Indicator Is Lit

"PF" (power failure)

"L2" Diagnostic Code

(low or no line voltage

condition)

"F# E#" (F1 E1, F3 E1,

etc.) variable service

codes.

AF (restricted air flow)

Possible Causes

For steam cycles, the water is not

properly connected with the dryer.

Odors are left in garments after

wearing.

A Smart Grid event may have

interrupted the Steam Refresh cycle.

Load removed before cooldown

portion of cycle complete.

Using Timed Dry cycle with a high

temperature setting.

The drying cycle has been interrupted

by a power failure.

There may be a problem with your

home power supply, keeping the

dryer's heater from turning on.

The dryer is in need of service.

The lint screen or vent is clogged;

the vent is crushed, kinked, or has

too many turns.

Make sure water is connected to the dryer. Check that water

inlet hose is connected to both the faucet and dryer's water inlet

valve. Check that the water supply is turned on.

To remove odors left in garments after wearing, select Steam

Refresh. This cycle is best for reducing wrinkles and odors from

dry loads consisting of wrinkle-free cotton, cotton-polyester

blends, common knits, and synthetics.

Rerun a Steam Refresh cycle. If necessary, turn off Smart Grid

monitoring during the cycle to prevent interruption.

Allow the dryer to complete the cooldown portion of the cycle

before removing the load.

Select an Automatic Cycle with a lower heat setting to avoid

overdrying the load.

Touch and hold START/PAUSE to restart the dryer or press

POWER to clear the display.

The dryer will continue to run when this diagnostic code is

present. Touch any pad to clear the code from the display and

return to the estimated time remaining.

NOTE: This error will only show during the initial installation.

Try the following:

•

Check to see if a household fuse has blown or circuit breaker

has tripped. Electric dryers use two household fuses or

breakers. Replace the fuse or reset the circuit breaker.

•

Confirm that the power cord is properly installed. Refer to

the Installation Instructions for details.

•

Select a Timed Dry heated cycle, and restart the dryer.

If the message persists, consult a qualified electrician.

If a code beginning with an "F" appears in the display, alternating

between F# and E#, the dryer control has detected a problem

that requires service. Call for service.

The dryer will continue to run when this diagnostic code is

present. Touch any key to clear the code from the display and

return to the estimated time remaining.

Try the following:

•

Clean lint screen.

•

Check to see if the vent run from the dryer to the wall is

crushed or kinked.

•

Confirm that the vent run from the dryer to the wall is free

of lint and debris.

•

Confirm that the exterior vent exhaust hood is free of lint

and debris.

•

Confirm that your vent system falls within the recommended

run length and number of elbows for the type of vent you are

using. Refer to "Plan Vent System" in the Installaton Instructions

for details.

Select a Timed Dry heated cycle, and restart the dryer.

If the message persists, have your entire home venting run

cleaned. Contact a venting specialist.

Solution