- ページ 11

ドライヤー Whirlpool Cabrio WGD6600WL0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool Cabrio WGD6600WL0 48 ページ。 Steam fabric care system gas dryer

8. Using pliers, tighten the couplings with an additional two-

Then, by placing a level in the crease on the side of the dryer

thirds turn.

between the top of the dryer and the dryer cabinet, check the

levelness from front to back.

A. Inlet to cold water

NOTE: Do not overtighten.

Damage to the coupling can

result.

9. Attach angled end of long hose to fill valve at bottom of dryer

back panel. Screw on coupling by hand until it is seated on fill

valve connector.

10. Using pliers, tighten the coupling with an additional two-

thirds turn.

If the dryer is not level, prop up the dryer using a wood block.

Use a wrench to adjust the legs up or down and check again for

levelness.

You can change your door swing from a right-side opening to a

left-side opening, if desired.

1. Place a towel or soft cloth on top of the dryer or work space

to protect the surface.

Remove the door assembly

1. Open the dryer door.

2. Remove the bottom screw from each of the 2 hinges that

attach the dryer door to the front panel of the dryer.

3. Loosen the top screw from each of the 2 hinges in Step 2.

NOTE: Do not overtighten.

Damage to the coupling can

result.

11. Check that the water faucets are on.

12. Check for leaks around "Y" connector, faucet and hoses.

Check the levelness of the dryer by first placing a level on the top

of the dryer near the console.

-A

A. Loosen these screws.

B. Remove these screws.

4. Remove the dryer door and the hinges by lifting upward on

the door. Lay the door on a flat, protected surface, with the

inside of the door facing up. Remove remaining 2 loose

screws from dryer front panel.