- ページ 7

ドライヤー Whirlpool Cabrio,- WED7300XのPDF インストールマニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool Cabrio,- WED7300X 16 ページ。 Top-loading high efficiency low-water washer
Whirlpool Cabrio,- WED7300X にも：取扱説明書 (40 ページ), 取扱説明書 (40 ページ), 取扱説明書 (36 ページ), 取扱説明書 (32 ページ), 取扱説明書 (40 ページ), 取扱説明書 (40 ページ), 寸法と設置について (1 ページ), 寸法マニュアル (2 ページ), 取扱説明書 (40 ページ), 取扱説明書 (48 ページ), 取扱説明書 (40 ページ), 取扱説明書 (40 ページ), 取扱説明書 (40 ページ), 取扱説明書 (44 ページ), 取扱説明書 (19 ページ), 使用とお手入れグード (44 ページ), 取扱説明書 (44 ページ)

12.

Secure drain hose

Laundry Tub

Standpipe

Secure drain hose to laundry tub leg, drain standpipe or inlet

hoses for wall standpipe with beaded tie strap.

LeveL Washer

IMPORTANT: Level washer properly to reduce excess noise

and vibration.

13.

Check levelness of washer

Place level here

With washer in its final location, place a level on top edges of

washer. Use side seam as a guide to check levelness of sides.

Check levelness of front using lid, as shown. Rock washer

back and forth to make sure all four feet make solid contact

with floor. If washer is level, skip to step 14.

LEVEL

Not Level

Wall

Place level here

Not Level

14.

Adjust leveling feet

Jam nut

If washer is not level, use a 9/16" or 14 mm open-end or

adjustable wrench to turn jam nuts clockwise on foot until they

are about 1/2" (13 mm) from the washer cabinet. Then turn the

leveling foot clockwise to lower the washer or counterclock-

wise to raise the washer. Recheck levelness of washer and

repeat as needed.

HELPFUL TIP: You may want to prop up front of washer

about 4" (102 mm) with a wood block or similar object that

will support weight of washer.

15.

Tighten leveling feet

Jam nut

When washer is level, use a 9/16" or 14 mm open-end or

adjustable wrench to turn jam nuts counterclockwise on

leveling feet tightly against washer cabinet.

HELPFUL TIP: You may want to prop washer with

wooden block.