- ページ 25

ドライヤー Whirlpool CEM2793BQのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool CEM2793BQ 48 ページ。 Commercial dryer gas or electric
Whirlpool CEM2793BQ にも：取付説明書 (48 ページ)

ページを印刷する

CHANGING

TO A 30- OR 60-MINUTE

TIMING

CAM

(on some models)

Electrical

Shock Hazard

Disconnect

power before making cam changes.

Failure to follow these instructions can result in death

or electrical shock.

5. Place new cam (hub side down) over clock shaft. Line up flat

side of shaft with flat side of cam hole. Check that drive lug

is in place.

Drive Lug

Coin-slide

models: You can install the 30-minute

or 60-minute

timing cam (shipped with dryer) as follows:

1. Unplug dryer or disconnect

power.

2. Unlock meter case.

3. Turn the timing cam by hand until the V-shaped notch lines

up below the ratchet tooth.

V-Shaped

Ratchet

Notch

Tooth

6. Turn cam until V-shaped notch lines up with ratchet tooth.

7. Press cam down in place on clock shaft. Make sure that

V-shaped notch clears the ratchet tooth.

4. Insert a narrow, flat-blade screwdriver under the timing cam

near the clock shaft. Gently lift cam straight up and off shaft,

making sure that the V-shaped notch clears the ratchet tooth.

8. Close and lock the meter case.

9. Plug in dryer or reconnect power.