- ページ 23

ドライヤー Whirlpool CGM2743BQのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool CGM2743BQ 48 ページ。 Commercial dryer gas or electric
Whirlpool CGM2743BQ にも：取付説明書 (48 ページ)

ページを印刷する

2. Grip dryer from top and rock back and forth, making sure all

four legs are firmly on floor. Repeat, rocking dryer from side

to side. If dryer rocks, go to Step 3 and adjust leveling legs.

(appearance may vary)

1. Check the electrical requirements. Be sure that you have the

correct electrical supply and the recommended grounding

method. See "Electrical Requirements."

2. Check that all parts are now installed. If there is an extra part,

go back through the steps.

3. Check that you have all of your tools.

4. Dispose of/recycle all packaging materials.

5. Plug into a grounded outlet, or connect power.

3. If dryer is not level, use a 1" or 25 mm open-end or

adjustable wrench to turn the leveling leg counterclockwise

to lower the dryer or clockwise to raise the dryer. Recheck

levelness of dryer and that all four legs are firmly in contact

with the floor. Repeat as needed.

HELPFUL TIP: You may want to prop up front of dryer about

4" (102 mm) with a wood block or similar object that will

support weight of dryer.

COMPLETE INSTALLATION

6. Check dryer operation (on some models, some accumulated

time may be on the timer due to factory testing). Close dryer

door. Depending on model, turn timer-set knob to the right

or insert coins and press slide in slowly. (Operating time will

accumulate per number of coinslide depressions, depending

on model, and type of timing cam used.) Push START button.

Using a full heat cycle (not the air cycle), let the dryer run for

at least five minutes. Dryer will stop when time is used up.

NOTE: Dryer door must be closed for dryer to operate.

When door is open, dryer stops, but timer continues to run.

To restart dryer, close door and push START button.

7. Open the dryer door. Check that the inside of the dryer is

warm. If the burner does not ignite and you can feel no heat

inside the dryer, shut off dryer for five minutes. Check that

all supply valve controls are in "ON" position and that the

electrical cord is plugged in. Repeat five-minute test.

8. If drying time is too long, make sure that the lint screen is

clean and that there are no obstructions to airflow in the

dryer vent system.

9. Restart the dryer and allow it to complete a full heat cycle

(not air cycle) to make sure it is working properly.

LEVELING