- ページ 26

ドライヤー Whirlpool CGM2745FQ0のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool CGM2745FQ0 29 ページ。 Commercial gas or electric

CHANGING TO A 30- OR 60-MINUTE TIMING CAM

(on some models)

WARNING

Electrical Shock Hazard

Disconnect power before making cam changes.

Failure to follow these instructions can result in death

or electrical shock.

Coin-slide models: You can install the 30-minute or 60-minute

timing cam (shipped with dryer) as follows:

1. Unplug dryer or disconnect power.

2. Unlock meter case.

3. Turn the timing cam by hand until the V-shaped notch lines

up below the ratchet tooth.

V-Shaped

Ratchet

Notch

Tooth

4. Insert a narrow, flat-blade screwdriver under the timing cam

near the clock shaft. Gently lift cam straight up and off shaft,

making sure that the V-shaped notch clears the ratchet tooth.

5. Place new cam (hub side down) over clock shaft. Line up flat

side of shaft with flat side of cam hole. Check that drive lug

is in place.

Drive Lug

6. Turn cam until V-shaped notch lines up with ratchet tooth.

7. Press cam down in place on clock shaft. Make sure that

V-shaped notch clears the ratchet tooth.

8. Close and lock the meter case.

9. Plug in dryer or reconnect power.