- ページ 12

ドライヤー Whirlpool CGM2793BQのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool CGM2793BQ 48 ページ。 Commercial dryer gas or electric
Whirlpool CGM2793BQ にも：取付説明書 (48 ページ)

ページを印刷する

ELECTRIC

DRYER INSTALLATION

REQUIREMENTS

Direct

Wire

Fire Hazard

Use 10 gauge copper wire.

Use a UL listed strain relief.

Disconnect power before making electrical connections.

Connect neutral wire (white or center wire) to center

terminal.

Ground wire (green or bare wire) must be connected

green ground connector.

Connect remaining 2 supply wires to remaining

2 terminals

(gold).

Securely tighten all electrical connections.

Failure to do so can result in death, fire, or

electrical shock.

if connecting

by direct

wire:

Power supply cable must match power supply (4-wire or 3-wire)

and be:

[]

Flexible armored cable or nonmetallic

sheathed copper

cable (with ground wire), covered with flexible metallic

conduit. All current-carrying

wires must be insulated.

[]

10-gauge solid copper wire (do not use aluminum).

[]

At least 5 ft. (1.52 m) long.

Electrical

Requirements

= Canada

only

Electrical

Shock Hazard

Plug into a grounded 4 prong outlet.

Failure to do so can result in death or electrical shock.

It is your responsibility:

[] To contact a qualified electrical installer.

[] To be sure that the electrical connection is adequate

and in conformance

with the Canadian Electrical Code,

C22.1 - latest edition and all local codes. A copy of the

above codes standard may be obtained from: Canadian

Standards Association,

178 Rexdale Blvd., Toronto, ON

M9W 1R3 CANADA.

[] To supply the required 4 wire, single phase, 120/240 volt,

60 Hz., AC only electrical supply on a separate 30-amp

circuit, fused on both sides of the line. A time-delay fuse

or circuit breaker is recommended.

Connect to an individual

branch circuit.

[] This dryer is equipped with a CSA International/_

Certified Power Cord intended to be plugged

/r,

kJ '_

into a standard 14-30R wall receptacle. The

II)

cord is 5 ft (1.52 m) in length. Be sure wall

\''

_-q ''J

receptacle is within reach of dryer's final

location.

4-Wire

Receptacle

(14-30R}

[]

Do not use an extension cord.

If you are using a replacement

power supply cord,

it is recommended

that you use Power Supply Cord

Replacement Part Number 9831317. For further information,

please reference the service numbers located in the

"Assistance or Service" section.

GROUNDING

INSTRUCTIONS

[] For a grounded, cord-connected

dryer:

This dryer must be grounded. In the event of malfunction or

breakdown, grounding will reduce the risk of electric shock

by providing a path of least resistance for electric current.

This dryer is equipped with a cord having an equipment-

grounding

conductor and a grounding

plug. The plug must

be plugged into an appropriate

outlet that is properly

installed and grounded in accordance with all local codes

and ordinances.

WARNING:

Improper connection of the equipment-

grounding

conductor can result in a risk of electric shock.

Check with a qualified electrician or service representative

or personnel if you are in doubt as to whether the dryer is

properly grounded. Do not modify the plug provided with

the dryer: if it will not fit the outlet, have a proper outlet

installed by a qualified electrician.

SAVE THESE

INSTRUCTIONS