- ページ 15

ドライヤー Whirlpool Commercial DryerのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool Commercial Dryer 28 ページ。 Commercial dryer gas (120-volt, 60-hz) or electric (120/240-volt, 60-hz)

ページを印刷する

If an Exhaust Hood Cannot be Used

The outside end of main vent should have a sweep elbow

directed downward.

12" min.

(305 mm)*

* Minimum clearance above

any accumulation of snow,

ice, or debris such as leaves

If main vent travels vertically through the roof, rather than

through wall, install a 180° sweep elbow on end of vent at least

2 ft. (610 mm) above surface of roof.

The opening in wall or roof shall have a diameter 1⁄2" (13 mm)

larger than vent diameter. Vent should be centered in opening.

Do not install screening over end of vent for best performance.

Make Gas Connection

1. Remove red cap from gas pipe on back of dryer.

2. Connect gas supply to dryer. Use a pipe thread compound

approved for the type of gas supplied. If flexible metal

tubing is used, be certain there are no kinks.

If necessary for service, open the toe panel by removing the

⁄

" hex-head screws from the bottom of the panel. Then

lift up on the panel while pulling the bottom of the panel

away from the dryer.

3. Open the shut-off valve in the gas supply line and make sure

the dryer has its own gas supply opened.

4. Test all connections by brushing on an approved

noncorrosive leak-detection solution. Bubbles will show

a leak. Correct any leaks found.

DRYER VENTING REQUIREMENTS

24" min.

(610 mm)

Multiple Dryer Venting

A main vent can be used for venting a group of dryers. The

main vent should be sized to remove 5663 l/min. (200 CFM)

of air per dryer. Large-capacity lint screens of proper design

may be used in main vent if checked and cleaned frequently.

The room where the dryers are located should have make-up

air equal to or greater than CFM of all the dryers in the room.

Back-draft Damper Kit, Part No. 3391910, is available from

your distributor and should be installed in the vent of each

dryer to keep exhausted air from returning into dryers and to

keep exhaust in balance within main vent. Unobstructed return

air openings are required.

Each vent should enter the main vent at an angle pointing in

the direction of the airflow. Vents entering from the opposite

side should be staggered to reduce the exhausted air from

interfering with the other vents.

air flow

air ow

The maximum angle of each vent entering the main vent

should be no more than 30°.

Keep air openings free of dry cleaning fluid fumes. Fumes

create acids which, when drawn through the dryer heating

units, can damage dryers and items being dried.

A clean-out cover should be located on the main vent for

periodic cleaning of the vent system.

GAS SUPPLY CONNECTION

30˚ max.