- ページ 23

ドライヤー Whirlpool Commercial DryerのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool Commercial Dryer 28 ページ。 Commercial dryer gas (120-volt, 60-hz) or electric (120/240-volt, 60-hz)

ページを印刷する

2. Grip dryer from top and rock back and forth, making sure all

four legs are firmly on floor. Repeat, rocking dryer from side

to side. If dryer rocks, go to Step 3 and adjust leveling legs.

If all four legs are in firm contact with floor, go to Step 4.

3. If dryer is not level, use a 1" or 25 mm open-end or adjustable

wrench to turn jam nuts clockwise (as viewed from above) on

legs until they are about 1/2" (13 mm) from the dryer cabinet.

Then turn the leveling leg counterclockwise to lower the dryer

or clockwise to raise the dryer. Recheck levelness of dryer and

that all four legs are firmly in contact with the floor. Repeat as

needed.

1. Check the electrical requirements. Be sure that you have the

correct electrical supply and the recommended grounding

method. See "Electrical Requirements."

2. Check that all parts are now installed. If there is an extra

part, go back through the steps.

3. Check that you have all of your tools.

4. Dispose of/recycle all packaging materials.

5. Plug into a grounded outlet, or connect power.

HELPFUL TIP: You may want to prop up front of dryer about 4"

(102 mm) with a wood block or similar object that will support

weight of dryer.

jam nut

Jam nut

4. When dryer is level and all four legs are firmly in contact with

the floor, use a 1" or 25 mm open-end or adjustable wrench

to turn jam nuts counterclockwise (as viewed from above)

on leveling legs tightly against dryer cabinet.

HELPFUL TIP: You may want to prop dryer with wooden

block.

COMPLETE INSTALLATION

6. Check dryer operation. Close dryer door. Insert coins and

press slide in slowly. (Operating time will accumulate per

number of coins and type of timing cam used.) Push START

button. Using a full heat cycle (not the air cycle), let the dryer

run for at least five minutes. Dryer will stop when time is

used up.

NOTE: Dryer door must be closed for dryer to operate.

When door is open, dryer stops, but timer continues to run.

To restart dryer, close door and push START button.

7. Open the dryer door. Check that the inside of the dryer is

warm. If the burner does not ignite and you can feel no heat

inside the dryer, shut off dryer for five minutes. Check that

all supply valve controls are in "ON" position and that the

electrical cord is plugged in. Repeat five-minute test.

8. If drying time is too long, make sure that the lint screen is

clean and that there are no obstructions to airflow in the

dryer vent system.

9. Restart the dryer and allow it to complete a full heat cycle

(not air cycle) to make sure it is working properly.

LEVELING