- ページ 13
ドライヤー Whirlpool CSP2761TQ4のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool CSP2761TQ4 36 ページ。 Commercial stacked dryer gas (120-volt,60-hz)or electric (120/240-volt,60-hz)
ページを印刷するPower Supply Cord,
Three=wire electrical
connection:
A. Spade terminals with upturned ends
B. Ring terminals
C. Neutral (white or center)
D. ¾" (19 mm) UL-Iisted strain relief
E. Neutral
Three-wire power supply cord must
have three, No. 10 copper wires and
match a three-wire receptacle of NEMA
Type 10-30R.
Use this method where local codes permit connecting
neutral ground wire to neutral wire:
A ___jr_
.................................
_
.:_
............
B
5. Loosen or remove the center terminal
L
_
block screw.
F
"*'[-_(_.
__I"
1
°-
E
............
7=
8.
9.
Connect the neutral wire (white or center)
of the power supply cord to the center,
silver-colored terminal screw of the
terminal block. Tighten screw.
Connect the other wires to outer terminal
block screws. Tighten screws.
Tighten strain relief screws.
Insert tab of the terminal block cover into
slot of the dryer rear panel. Secure cover
with hold-down screw.
A. External ground conductor screw
B. Center terminal block screw
C. Outer terminal block screws
D. Strain relief screw
E. Neutral (center wire)
F. Appliance neutral ground wire
Use this method where local codes do not permit
connecting
neutral ground wire to neutral wire:
5. Remove the center terminal block screw.
6. Remove the appliance neutral ground wire
from the external ground conductor
screw. Connect the appliance neutral
ground wire and the neutral wire (white or
center) of the power supply cord under
the center, silver-colored terminal block
screw. Tighten screw.
7. Connect the other wires to outer terminal
block screws. Tighten screws.
8. Tighten strain relief screws.
9. Insert tab of the terminal block cover into
slot of the dryer rear panel. Secure cover
with hold-down screw.
10. After reattaching the terminal cover,
connect a separate copper ground wire
from the external ground conductor screw
to an adequate ground.
If codes permit and a separate ground wire is
used, it is recommended that a qualified
electrician determine that the ground path is
adequate.
A ..........
!
C
t
I I
\l
B
........
A. Separate copper ground wire
B. External ground conductor screw
C. Appliance neutral ground wire
D. Center terminal block screw
E. Outer terminal block screws
F. Strain relief screw
G. Neutral (center wire)
13