- ページ 16

ドライヤー Whirlpool duet GEW9200LQ0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool duet GEW9200LQ0 28 ページ。 Duet electronic electric dryer

Reverse the hinge and hinge bracket

1. Place the inner door, screwhead side up, on the work surface.

2. Remove the 4 screws that hold the hinge to the door.

3. Remove the 2 screws that hold the handle bracket to the

door.

4. Move hinge to the other side and reattach.

5. Move handle bracket to the other side and reattach.

6. Set the inner door assembly aside.

Reinstalling the door

1. Check for fingerprints on the glass. Clean if necessary.

2. Place the inner door assembly into the outer door assembly.

Align the hinge in the opening on the side. To fit correctly, the

inside door assembly edge is completely inside the outside

door assembly edge.

3. Reassemble the inner and outer door assemblies with the 6

screws.

4. Insert the new handle into the side opening of the door. Make

sure the handle seats all the way in, and the holes line up with

the holes in the door. Reattach with 2 screws.

5. Use a small flat-head screwdriver to remove hole plugs in the

door opening. Slide the head of the screwdriver under the

cap of each hole plug, being careful not to scratch the dryer

surface. Lift up. Remove the hole plugs in the door opening

and insert in the opposite side.

6. Insert a screw in the second opening from the top of the

hinge opening and partially tighten. Hang the door by placing

the top hinge keyhole over the second screwhead and tighten

the screw. By putting this screw in first, the door will hang in

place while you insert and tighten the remaining 4 screws.

Install new handle filler and hinge cover

1. Using the new handle filler provided in the reversing kit, hook

the top of the handle filler onto the loosened upper door trim.

Snap the joined pieces into place. You may need to use the

heel of your hand to firmly snap the pieces back into place.

2. Hook the bottom of the handle filler onto the lower door trim

and snap into place.

3. Repeat steps 1 and 2 to install the hinge cover on the

opposite side.

4. Close the door and check that it latches securely.