- ページ 24

ドライヤー Whirlpool DUET SPORT W10151580BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool DUET SPORT W10151580B 28 ページ。 Duet sport electronic electric dryer

ページを印刷する

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

Dryer Operation

Dryer will not run

Has a household fuse blown, or has a circuit breaker

tripped?

There may be 2 fuses or circuit breakers for the dryer. Check

that both fuses are intact and tight, or that both circuit

breakers have not tripped. Replace the fuse or reset the

circuit breaker. If the problem continues, call an electrician.

Is the correct power supply available?

Electric dryers require 240-volt power supply. Check with a

qualified electrician.

Was a regular fuse used?

Use a time-delay fuse.

Is the dryer door firmly closed?

Was the Power button pressed?

Was the Start button firmly pressed?

Press and hold for 1 second.

No heat

Has a household fuse blown, or has a circuit breaker

tripped?

The drum may be turning, but you may not have heat. Electric

dryers use 2 fuses or circuit breakers. Replace the fuse or

reset the circuit breaker. If the problem continues, call an

electrician.

Unusual sounds

Has the dryer had a period of non-use?

If the dryer hasn't been used for a while, there may be a

thumping sound during the first few minutes of operation.

Is a coin, button, or paper clip caught between the drum

and front or rear of the dryer?

Check the front and rear edges of the drum for small objects.

Clean out pockets before laundering.

Are the four legs installed, and is the dryer level front to

back and side to side?

The dryer may vibrate if not properly installed. See

"Installation Instructions."

TROUBLESHOOTING

to possibly avoid the cost of a service call...

In U.S.A. www.whirlpool.com/help - In Canada www.whirlpool.ca

Is the clothing knotted or balled up?

When balled up, the load will bounce, causing the dryer to

vibrate. Separate the load items and restart the dryer.

Dryer displaying code message

"PF" (power failure), check the following:

Was the drying cycle interrupted by a power failure?

Press and hold START to restart the dryer.

"F-" Variable (F-01, F-22, F-23, F-26) service codes (the

display alternately flashes "F-" and then the error code

number):

Call for service.

Dryer Results

Clothes are not drying satisfactorily, drying times are too

long, or load is too hot

Is the lint screen clogged with lint?

Lint screen should be cleaned before each load.

WARNING

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in death

or fire.

Is the exhaust vent or outside exhaust hood clogged with

lint, restricting air movement?

Run the dryer for 5-10 minutes. Hold your hand under the

outside exhaust hood to check air movement. If you do not

feel air movement, clean exhaust system of lint or replace

exhaust vent with heavy metal or flexible metal vent. See

"Venting Requirements."