- ページ 19

ドライヤー Whirlpool Easy Clean 100 SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool Easy Clean 100 Series 24 ページ。 Electric and gas dryers
Whirlpool Easy Clean 100 Series にも：取扱説明書 (27 ページ)

ページを印刷する

EMOVING ACCUMULATED LINT FROM INSIDE THE DRYER CABINET

Remove 2 internal screws from front panel

flanges (near top front corners). Lift front panel

slightly, lifting off lower clips (see lower clip

inset of illustration below). Slowly pull front

panel forward, disengaging panel from drum.

(Drum will drop slightly.)

Move front panel aside and rest edge against

side of dryer. Avoid disconnecting wire clips

(see wire clips inset of illustration below) or

damaging wires.

Remove any lint using a vacuum cleaner or

soft brush.

Reassemble in reverse order. Before closing

the top, check the following:

– Drum seal must be flared out (see drum seal

insets of illustration) and properly positioned

against panel at back of drum. Rotate drum

counterclockwise one full turn to check

drum seal.

– Belt should be centered and tight on

dryer drum.

– Wire clip retainer, which holds the door

switch wires, must be secured to top of front

panel (see wire clips inset of illustration) and

along top edge of side panel. Door wires

must not touch drum when dryer is

operating.

10.

Replace top panel. Top and front panels must

be securely in place before operating dryer.

11.

Level the dryer if necessary.

12.

Plug in dryer or turn on power supply.

Burner

(gas models only)

Dryer with front panel removed

Drum

Seal

right

side

panel

Lower

clip

CARING FOR YOUR DRYER

CONT

(

Motor

Drum

Seal

wrong

front

panel

Wire clips

)