- ページ 10

ドライヤー Whirlpool WGD7300DWのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WGD7300DW 44 ページ。 Gas and electric dryer 29" wide models
Whirlpool WGD7300DW にも：取扱説明書 (40 ページ)

ページを印刷する

A. 3/8" flexible gas connector

B. 3/8" pipe to flare adapter fitting

C. 1/8" NPT minimum plugged tapping

D. 1/2" NPT gas supply line

E. Gas shutoff valve.

GAS SUPPLY CONNECTION REQUIREMENTS

Use an elbow and a 3/8" flare x 3/8" NPT adapter fitting

■

between the flexible gas connector and the dryer gas pipe,

as needed to avoid kinking.

Use only pipe-joint compound. Do not use TEFLON

■

This dryer must be connected to the gas supply line with a

■

listed flexible gas connector that complies with the standard

for connectors for gas appliances, ANSI Z21.24 or CSA 6.10.

BURNER INPUT REQUIREMENTS

Elevations above 2,000 ft. (610 m):

When installed above 2,000 ft. (610 m) a 4% reduction of the

■

burner Btu rating shown on the model/serial number plate is

required for each 1,000 ft. (305 m) increase in elevation.

Gas supply pressure testing

The dryer must be disconnected from the gas supply piping

■

system during pressure testing at pressures greater than

1/2 psi.

Dryer gas pipe

The gas pipe that comes out through the rear of your dryer

■

has a 3/8" male pipe thread.

3/8" NPT dryer gas pipe

tape.

(32 mm)

(235 mm)

INSTALL LEVELING LEGS

Prepare dryer for leveling legs

To avoid damaging floor, use a large flat piece of cardboard

from dryer carton; place under entire back edge of dryer.

Firmly grasp dryer body (not console panel) and gently lay

dryer down on cardboard.

Screw in leveling legs

Using a wrench and tape measure, screw leveling legs into

leg holes until bottom of foot is approximately 1/2" (13 mm)

from bottom of dryer.

Now stand the dryer on its feet. Slide the dryer until it is

close to its final location. Leave enough room to connect

the exhaust vent.

For mobile home use

Gas dryers must be securely fastened to the floor.

Mobile home installations require a Mobile

Home Installation Hold-down Kit. For

ordering information please reference

the "Use and Care Guide."