- ページ 10

ドライヤー Whirlpool WGD7600XW0のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WGD7600XW0 32 ページ。 27" gas dryer
Whirlpool WGD7600XW0 にも：取付説明書 (32 ページ)

ページを印刷する

1. Troubleshooting

■

Do not use an exhaust hood with a magnetic latch.

Improper venting can cause moisture and lint to collect

indoors, which may result in:

Moisture damage to woodwork, furniture, paint, wallpaper,

carpets, etc.

Housecleaning problems and health problems.

Plan Vent System

Choose your exhaust installation type

Recommended exhaust installations

Typical installations vent the dryer from the rear of the dryer. Other

installations are possible.

A. Dryer

E. Clamps

B. Elbow

F. Rigid metal or flexible metal vent

C. Wall

G. Vent length necessary to connect elbows

D. Exhaust hood

H. Exhaust outlet

Optional exhaust installations

■

Exhaust Cover Kit (to cover unused exhaust holes):

Part Number W10186596 - all models

This dryer can be converted to exhaust out the right side, left side

or through the bottom. If you prefer, you may contact your local

dealer to have the dryer converted.

A. Standard rear offset exhaust installation

B. Left or right side exhaust installation

C. Bottom exhaust installation

Alternate installations for close clearances

Venting systems come in many varieties. Select the type best

for your installation. Two close-clearance installations are shown.

Refer to the manufacturer's instructions.

A. Over-the-top installation (also available with one offset elbow)

B. Periscope installation

NOTE: The following kits for close clearance alternate installations

are available for purchase. Please see the "Assistance or Service"

section in your Use and Care Guide to order.

■

Over-the-Top Installation:

Part Number 4396028

■

Periscope Installation (For use with dryer vent to wall vent

mismatch):

Part Number 4396037 - 0" (0 mm) to 18" (460 mm) mismatch

Part Number 4396011 - 18" (460 mm) to 29"(737 mm) mismatch

Part Number 4396014 - 29" (737 mm) to 50" (1270 mm)

mismatch

Special provisions for mobile home installations

The exhaust vent must be securely fastened to a noncombustible

portion of the mobile home structure and must not terminate

beneath the mobile home. Terminate the exhaust vent outside.