- ページ 22

ドライヤー Whirlpool WGD8500DWのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WGD8500DW 44 ページ。 Gas and electric
Whirlpool WGD8500DW にも：取付説明書 (44 ページ)

REVERSE DOOR SWING

Flat-blade screwdriver

Min. 8" long TORX T25

® †

screwdriver

You can change your door swing from a right-side opening

to a left-side opening, if desired.

1. Place a towel or soft cloth on top of dryer or work space

to avoid damaging the surface.

Remove door from dryer cabinet

1. Open the dryer door.

2. Using a T25

screwdriver, remove screws (A) and then (B)

screws from each of the two hinges that attach dryer door to

front panel of dryer. Set the hinge screws off to the side for

reinstalling the door.

3. Remove the dryer door by lifting upward and out to lift the

door off the cabinet. Lay the door on a flat, covered surface,

with the inside of the door facing up.

Plastic putty knife

#2 Phillips screwdriver

4. Remove the 2 plastic plugs (A) located outside the dryer

door opening.

5. Install 2 plastic plugs (A) into screw holes where the hinges

were removed in Step 4.

Reverse the strike

1. Remove the door strike (A) from the dryer door opening.

2. Remove the cosmetic screw (B) opposite the door strike (A).

A. Door strike

B. Cosmetic screw

3. Reinstall the door strike and cosmetic screw on the opposite

side of dryer door opening from where they were removed.

NOTE: Door strike and plugs must be on the same side

of the dryer door opening.

® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.

†