- ページ 17

ドライヤー Whirlpool WGD94HEXL1のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WGD94HEXL1 40 ページ。 Electronic dryer

ページを印刷する

First try the solutions suggested here or visit our website at www.whirlpool.com/help

for assistance and to possibly avoid a service call.

mfyou experience

Possible

Causes

Solution

Odors

Recent painting, staining, or

varnishing in the area where your

dryer is located.

For steam cycles, the water is not

properly connected with the dryer.

Odors are left in garments after

wearing.

ventilate the area. When the odors or fumes are gone from

the area, rewash and dry the clothing.

Make sure water is connected to the dryer. Check that water

inlet hose is connected to both the faucet and dryer's water

inlet valve. Check that the water supply is turned on.

To remove odors left in garments after wearing, select Quick

Refresh for small loads of up to 9 garments. This cycle is

best for reducing wrinkles and odors from loads consisting of

wrinkle-free cotton, cotton polyester blends, common knits,

and synthetics.

Load too hot

Load removed before cooldown

Allow the dryer to complete the cooldown

portion of the cycle

portion of cycle complete,

before removing the load.

Using Timed Dry cycle with a high

temperature

setting.

Select an Auto Dry cycle with a lower heat setting to avoid

overdrying the load.

"PF" (power failure)

The drying cycle has been

Press and hold START to restart the dryer.

interrupted by a power failure.

There may be a problem with your

home power supply keeping the

dryer's heater from turning on.

The lint screen or vent is clogged;

the vent is crushed or kinked or

has too many turns.

"L2" Diagnostic Code

(low or no line voltage

condition)

"AF" (low airflow

condition)

"F# E#" (F1 El, F3 El, etc.)

variable service codes.

The dryer is in need of service.

The dryer will continue to run when this diagnostic code is

present. Press any key to clear the code from the display and

return to the estimated time remaining.

Try the following:

Check to see if a household fuse has blown or circuit breaker

has tripped. Electric dryers use two household fuses or

breakers. Replace the fuse or reset the circuit breaker.

Confirm the power cord is properly installed. Refer to

the hstallation

hstructions

for details.

Select a Timed Dry heated cycle, and restart the dryer.

Hfthe message persists, consult a qualified electrician.

The dryer will continue to run when this diagnostic code is

present. Press any key to clear the code from the display and

return to the estimated time remaining.

Try the following:

• Clean lint screen.

• Check to see if the vent run from the dryer to the wall is

crushed or kinked.

• Confirm the vent run from the dryer to the wall is free of lint

and debris.

Confirm the exterior vent exhaust hood is free of lint and debris.

Confirm your vent system falls within the recommended

run

length and number of elbows for the type of vent you are using.

Refer to "Plan Vent System" in the hstallaton

hstructions

for

details.

Select a Timed Dry heated cycle, and restart the dryer.

Hfthe message persists, have your entire home venting run

cleaned.

Hfa code beginning with an "F" appears in the display.

Alternating

between F# and E#, the dryer control has

detected a problem that requires service. Call for service.