- ページ 14
ドライヤー Whirlpool WGD97HEXW0のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WGD97HEXW0 38 ページ。 Gas dryer
Whirlpool WGD97HEXW0 にも： 取扱説明書 (36 ページ)
ページを印刷する
CONNECT
_NT
1,
Connect
vent to exhaust
outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
2=
Move dryer to final
location
Move dryer to final location, taking care not to crush or
kink vent.
After dryer is in place, remove corner posts and cardboard
from under dryer.
Place
level here
mm
Check levelness of dryer from
©
J
side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing system
to operate correctly
Not Level
LEVEL
Not Level
2,
Tighten
and adjust
leveling
legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once legs are level, make sure all four legs are snug against
the floor before tightening them.
14