- ページ 11
ドライヤー Whirlpool WHD5090GW0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WHD5090GW0 36 ページ。 Heat pump dryer
ページを印刷する
10.
If an automatic cycle was selected,
set dryness level
Wool
Bulky/Bedding
Air Dry
Dryness
Level
Refresh
Timed Dry
When you select an automatic cycle, the indicator light above
"Dryness Level" lights up. Turn the knob to select the desired
level. As you turn the knob, an indicator light will light up next
to the dryness levels to the right of the knob. Stop turning
when the indicator next to the desired level lights up. Press
the knob to confirm your selection.
11.
Select any additional options
Wool
Air Dry
Refresh
Timed Dry
After setting drying time or dryness level, the indicator light
above "Options" lights up. Turn the knob to select the desired
option(s). As you turn the knob, the option symbols above the
Options button will light up one at a time as you turn the knob.
Stop turning when the symbol of the desired option lights up.
Press the knob to confirm your selection.
Not all options and settings are available with all program/
*
cycles. See "Program/Cycle Guide" for available options
and settings.
12.
Touch Start/Pause button to begin
drying program/cycle
Touch the Start/Pause button to start the drying program/
cycle. To pause a program/cycle in progress, touch the Start/
Pause button once, then touch again to continue the program/
cycle. To cancel a program/cycle, touch the Power button.
X-Dry
Damp
*
Options
X-Dry
Dry
Damp
Dry
13.
Touch Power button to turn off
dryer after program/cycle ends
When the display indicates that the cycle has finished, touch
the Power button to turn off the dryer. Open the door and take
out your laundry.
Dry
To save energy, the dryer turns off automatically about
a quarter hour after the program/cycle ends.
Dry
If not turned off right after the program/cycle ends, the
dryer will tumble the laundry for about 10 minutes to prevent
wrinkling. The display shows an animation.
NOTE: If the Power button is touched and held, a countdown
will be displayed. At the end of the countdown, any errors will
be erased and the program/cycle will restart.
14.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle has completed
to reduce wrinkling.
Adapting the dryer to water conductivity
The drying results are affected by the conductivity of the water
used during washing. If, by modifying the available dryness
levels (damp dry, dry, and extra dry), you are not satisfied with
the final drying results, you can adapt the water conductivity
level. The dryer comes with preset level 3. Choose between
level 1 (most damp results) and 5 (most dry results).
1. Touch and hold the Program button. The
display will count down until the Conductivity
Adjustment symbol on the display flashes
and the current setting is shown.
2. Turn the knob to adjust the level (1-2-3-4-5). Press the
knob to confirm your selection.
NOTE: This new setting will affect all future cycles. If the
desired drying results are attained, water conductivity will
not require further adjustment.
Mixed
Heavy Duty
Normal
Synthetics
Delicates
P
Program
Cycle
Signal
3 Sec
11