- ページ 4
ドライヤー Whirlpool WTW5000DWのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WTW5000DW 20 ページ。 Top-loading high efficiency
Whirlpool WTW5000DW にも： 取扱説明書 (36 ページ), 取扱説明書 (36 ページ)
ページを印刷する
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.
Tools needed:
Flat-blade screwdriver
Wire stripper
(direct wire installations)
1/4" nut driver
(recommended)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Tape measure
4
INSTALLATION REQUIREMENTS
#2 Phillips screwdriver
Tin snips
(new vent installations)
Vent clamps
Utility knife
Pliers
Level
Parts supplied (all models):
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed:
Check local codes. Check existing electrical supply and venting,
and read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Mobile home installations require metal exhaust system hardware,
available for purchase from the dealer from whom you purchased
your dryer. For further information, please reference the
"Assistance or Service" section of the "Use and Care Guide".
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL listed 30-amp power supply cord, rated 120/240 volt
■
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to the
dryer must end in ring terminals or spade terminals with
upturned ends.
A UL listed strain relief.
■
Caulking gun and
compound (for installing
new exhaust vent)