- ページ 18

ドライヤー Whirlpool WTW7500GCのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WTW7500GC 40 ページ。 Electronic dryer
Whirlpool WTW7500GC にも：取扱説明書 (48 ページ), 取扱説明書 (32 ページ)

ページを印刷する

Special provisions for mobile homes:

Exhaust vent must be securely fastened to a noncombustible

portion of mobile home and must not terminate beneath the

mobile home. Terminate exhaust vent outside.

Moblie Home Exhaust installation

Determine vent path:

Select route that will provide straightest and most direct

■

path outdoors.

Plan installation to use fewest number of elbows and turns.

■

When using elbows or making turns, allow as much room

■

as possible.

Bend vent gradually to avoid kinking.

■

Use as few 90° turns as possible.

■

Determine vent length and elbows needed for best

drying performance:

Use following Vent System Chart to determine type of vent

■

material and hood combinations acceptable to use.

NOTE: Do not use vent runs longer than those specified

in Vent System Chart. Exhaust systems longer than those

specified will:

Shorten life of dryer.

■

Reduce performance, resulting in longer drying times

■

and increased energy usage.

The Vent System Charts provide venting requirements that

will help achieve best drying performance.

Vent System Chart

Number of

Type

90° turns

of vent

or elbows

Rigid metal

NOTE: Bottom exhaust installations have a 90° turn inside the

dryer. To determine maximum exhaust length, add one 90° turn

to the charts.

Box/louvered

Angled

hoods

58 ft. (17.7 m)

64 ft. (20 m)

54 ft. (16.5 m)

48 ft. (14.6 m)

44 ft. (13.4 m)

38 ft. (11.6 m)

35 ft. (10.7 m)

29 ft. (8.8 m)

27 ft. (8.2 m)

21 ft. (6.4 m)

INSTALL VENT SYSTEM

Install exhaust hood

Install exhaust hood and use caulking compound to seal

exterior wall opening around exhaust hood.

Connect vent to exhaust hood

Vent must fit over the exhaust hood. Secure vent to exhaust

hood with 4" (102 mm) clamp. Run vent to dryer location

using straightest path possible. Avoid 90° turns. Use clamps

to seal all joints. Do not use duct tape, screws, or other

fastening devices that extend into interior of vent to secure

vent, because they can catch lint.

12" min.

(305 mm)

12" min.

(305 mm)