- ページ 19

ドライヤー Whirlpool XCGM2765のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool XCGM2765 23 ページ。 Commercial gas or electric dryer

1. Check the electrical requirements. Be sure that you have

the correct electrical supply and the recommended earthing

method. See "Electrical Requirements."

2. Check that all parts are now installed. If there is an extra part,

go back through the steps.

3. Check that you have all of your tools.

4. Dispose of/recycle all packaging materials.

WARNING

Electric Shock Hazard

This dryer must be earthed.

Securely tighten all electrical connections.

Failure to do so can result in death, fire, or

electric shock.

5. Plug into a grounded outlet, or connect power.

COMPLETE INSTALLATION

6. Check dryer operation (some accumulated time may be

on the timer due to factory testing). Close dryer door. Insert

coins in slide and press slide in slowly. (Operating time will

accumulate per number of coins and type of timing cam

used.) Push START button. Using a full heat cycle (not the

air cycle), let the dryer run for at least five minutes. Dryer will

stop when time is used up.

NOTE: Dryer door must be closed for dryer to operate.

When door is open, dryer stops, but timer continues to run.

To restart dryer, close door and push START button.

7. Gas models only: Open the dryer door. Check that the

inside of the dryer is warm. If the burner does not ignite and

you can feel no heat inside the dryer, shut off dryer for five

minutes. Check that all supply valve controls are in "ON"

position and that the electrical cord is plugged in. Repeat

five-minute test.

8. If drying time is too long, make sure that the lint screen is

clean and that there are no obstructions to airflow in the

dryer vent system.

9. Restart the dryer and allow it to complete a full heat cycle

(not air cycle) to make sure it is working properly.