- ページ 8

ドライヤー Whirlpool YWED7990XG0のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool YWED7990XG0 32 ページ。 Gas dryer

ページを印刷する

gAS DRYER POWER HOOKUP

ELECTRICAL REQUIREMENTS

It is your responsibility to supply the required 120 Volt,

■

60 Hz, AC only, 15- or 20- amp fused electrical supply. A

time-delay fuse or circuit breaker is recommended. It is also

recommended that a separate circuit serving only this dryer

be provided.

GROUNDING INSTRUCTIONS

For a grounded, cord-connected dryer:

�

This dryer must be grounded. In the event of malfunction or

breakdown, grounding will reduce the risk of electric shock

by providing a path of least resistance for electric current.

This dryer is equipped with a cord having an equipment-

grounding conductor and a grounding plug. The plug must

be plugged into an appropriate outlet that is properly

installed and grounded in accordance with all local codes

and ordinances.

WARNING:

Improper connection of the equipment-

grounding conductor can result in a risk of electric shock.

Check with a qualified electrician or service representative

or personnel if you are in doubt as to whether the dryer is

properly grounded. Do not modify the plug provided with

the dryer: if it will not fit the outlet, have a proper outlet

installed by a qualified electrician.

SAVE THESE INSTRUCTIONS

GAS SUPPLY REQUIREMENTS

GAS TYPE

Natural Gas:

This dryer is equipped for use with Natural gas. It is design-

certified by CSA International for LP (propane or butane) gases

with appropriate conversion.

Your dryer must have the correct burner for the type of gas

■

in your home. Burner information is located on the rating

plate in the door well of your dryer. If this information does

not agree with the type of gas available, contact your dealer

or call the phone numbers referenced in the "Assistance

or Service" section of your "Use and Care Guide".

LP Gas Conversion:

IMPORTANT: Conversion must be made by a qualified

technician.

No attempt shall be made to convert the dryer from the gas

specified on the model/serial rating plate for use with a different

gas without consulting your gas company.

GAS SUPPLY LINE

Must include 1/8" NPT minimum plugged tapping accessible

■

for test gauge connection, immediately upstream of the gas

connection to the dryer.

A. 3/8" flexible gas connector

B. 3/8" pipe to flare adapter fitting

C. 1/8" NPT minimum plugged tapping

D. 1/2" NPT gas supply line

E. Gas shutoff valve.