- ページ 24

ドライヤー Whirlpool YWED85HEFC2のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool YWED85HEFC2 48 ページ。

Reverse door swing: square-shaped door

Remove door from dryer

Using a T25

screwdriver, remove the four screws securing

the door hinge to the dryer and lift up and out to remove

the door. Place the door on a soft towel or other non-scratch

surface. Retain or set aside the four screws.

Move the door strike

Using a T25

screwdriver, remove the two screws securing

the door strike to the door frame of the dryer. Remove the

four screws above and below the door strike and set aside

for later use. Rotate the strike 180° and attach to the opposite

side of dryer door frame, as shown.

Remove inner door from outer door

Release tab

Position the door with the inside of the door facing up.

Using a Phillips screwdriver, remove the 13 screws securing

the inner door to the outer door. Lift off the inner door and

set aside.

NOTE: There is a small release tab on each side of the door.

If the inner and outer door do not separate easily, slide a

credit card, putty knife, or similar fl at object between the inner

and outer doors at the locations shown to release the tab.

Remove hinge and latch

from inner door

Hinge

Using a T25

screwdriver, remove the three screws securing

the latch plate and the fi ve screws holding the hinge assembly

in place.

Release tab

Latch