- ページ 15
ドライヤー Whirlpool YWED92HEFBD2のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool YWED92HEFBD2 48 ページ。
ページを印刷するLEVEL DRYER
1.
Level dryer
Place
level here
Check levelness of dryer from
side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing
system to operate correctly.
Not Level
2.
Adjust leveling legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the oor and the dryer does not rock.
LEVEL
Not Level
COMPLETE INSTALLATION
CHECKLIST
❑
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
❑
Check that you have all of your tools.
❑
Dispose of/recycle all packaging materials.
❑
Be sure the water faucets are on.
❑
Check for leaks around "Y" connector, faucet, and hoses.
❑
Check dryer's nal location. Be sure vent is not crushed
or kinked.
❑
Check that dryer is level. See "Level Dryer."
❑
Remove lm on console and any tape remaining on dryer.
❑
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
❑
Read "Dryer Use" in your Use and Care Guide.
❑
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which
will reduce product performance. Excessive scale buildup
may lead to the need for certain part replacement or repair.
Electric Models:
❑
Plug into a grounded outlet.
Gas Models:
❑
Plug into a grounded outlet.
❑
Check that gas supply is on.
❑
Check for leaks.
❑
Check to be sure that the exible gas line is not crushed
or kinked.
All Models:
❑
Select a Timed Dry heated cycle and start dryer. Do not
select Air Only Temperature setting.
If dryer will not start, check the following:
• Start button has been pressed rmly.
• Dryer is plugged into an outlet and/or electrical supply
is connected.
• Household fuse is intact and tight, or circuit breaker
has not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its rst cycle.
NOTE: You may notice an odor when dryer is rst heated. This
odor is common when heating element is rst used. The odor
will go away.
15