- ページ 22
ドライヤー Whirlpool YWED9600TW1のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool YWED9600TW1 48 ページ。 Electronic electric dryer
ページを印刷する
Clothes are not drying satisfactorily,
drying times are too
long, or load is too hot
•
Is the lint screen clogged
with lint?
Lint screen should be cleaned before each load.
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow
these instructions can result in death
or fire.
Is the exhaust vent or outside exhaust hood clogged
with
lint, restricting air movement?
Run the dryer for 5-10 minutes. Hold your hand under the
outside exhaust hood to check air movement.
If you do not
feel air movement, clean exhaust system of lint or replace
exhaust vent with heavy metal or flexible metal vent. See the
Installation Instructions.
Are fabric softener sheets blocking the grille?
Use only one fabric softener sheet, and use it only once.
Is the exhaust vent the correct
length?
Check that the exhaust vent is not too long or has too many
turns. Long venting will increase drying times. See the
Installation Instructions.
Is the exhaust vent diameter the correct
size?
Use 4" (10.2 cm) diameter vent material.
Explosion
Hazard
Keep flammable
materials
and vapors, such as
gasoline,
away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion,
or fire.
•
Is the dryer located
in a room with temperature
below
45°F (7°0)?
Proper operation of dryer cycles requires temperatures
above
45°F (7°C).
Is the dryer located in a closet?
Closet doors must have ventilation openings at the top and
bottom of the door. The front of the dryer requires a minimum
of 1" (2.5 cm) of airspace, and, for most installations, the rear
of the dryer requires 5" (12.7 cm). See the Installation
Instructions.
•
Has the Air Only temperature
setting been selected?
Select the right temperature for the types of garments being
dried. See "Additional Features."
•
Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.
Are clothes coming out of the Refresh cycle with damp or
wet spots?
Under certain environmental
or installation conditions you
may experience underdrying.
Select the Touch Up cycle
(20 min. default time), which can be customized
by selecting
High temperature and/or additional cycle time by pressing
the Dry Time Up button.
Cycle time too short
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
•
Is the automatic cycle ending early?
The load may not be contacting the sensor strips. Level the
dryer.
Change the dryness level setting on Automatic Cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle.
Lint on load
•
Is the lint screen clogged?
Clean lint screen. Check for air movement.
Stains on load or drum
Was dryer fabric
softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can
stain your garments. Do not use fabric softener sheets with
steam cycles.
Drum stains are caused by dyes in clothing (usually blue
jeans). This will not transfer to other clothing.
22