ページを印刷するalarm silence (silence mode) on the smoke alarm device
cover, the alarm will silence to indicate that the alarm is in a
temporarily desensitised condition.
The smoke alarm device will automatically reset after
approximately 10 minutes, if after this period, particles of
combustion are still present, the alarm will sound again.
The alarm silencer (silence mode) can be pressed repeatedly
until the air has been cleared of the condition causing the
alarm.
CAUTION: Before using the alarm silence mode (silence),
identify the source of the smoke and be certain a safe
condition exists.
DANGER: If the alarm sounds, and it is not being tested,
it means the unit is sensing smoke, THE SOUND OF
THE ALARM REQUIRES YOUR IMMEDIATE
ATTENTION AND ACTION.
Maintenance and Cleaning:
In addition to weekly testing, the alarm requires periodic
cleaning to remove dust, dirt, and debris.
Clean the alarm at least once a month to remove dust, dirt,
or debris.
Use a vacuum cleaner with a soft brush to vacuum all sides
and covers of smoke alarm device.
This alarm has a low battery monitor which will cause the
alarm to "chirp" approx every 40 seconds and the red LED
flash once at the same time for a minimum of thirty days
when the battery gets low.
If there is a defective battery or other failures, you can refer
to "Trouble shooting" for solution, if there are still failures
during warranty, you can return to your retailer.
WARNING: The battery is sealed in the cover and not
replaceable. Please replace with another new alarm if the
low battery chirp occurs.
IMPORTANT: Do not attempt to remove the cover to clean
inside. This will affect warranty.
Repair:
Caution: Do not attempt to repair the alarm. It will affect
your warranty. If the alarm is not operating properly, and
is still under warranty, return it to the original place of
purchase. Pack it in a well-padded carton, and ship to the
original place of purchase. If the alarm is no longer under
warranty, have a licensed electrician replace it immediately
with a comparable alarm.
Trouble shooting:
Problem
Smoke alarm device does
not sound when tested.
The alarm "chirps" and red
LED flashes once every 40
seconds.
Smoke alarm device chirp
occurs every 40 seconds
(alarm goes into fault
mode).
Smoke alarm device
sounds unwanted alarms
intermittently or when
residents are cooking,
taking showers, etc.
The alarm sounds different
from normal. It starts and
stops.
- 3 -
Document NO.: FP522V-001 2020.02.18 Version: A
Method of disposal
1. Fit the alarm on the
bracket and turn the
alarm body clockwise,
until matching well on
the bracket.
2. Clean smoke alarm
device. Please refer to
the "maintenance and
cleaning" section.
3. If there are still failures
during warranty, you can
return to your retailer.
4. If the unit is out of
warranty, please replace
another new alarm.
The battery is under low
battery status, please
replace the smoke alarm
device.
Clean smoke alarm
device. Please refer to
the "maintenance and
cleaning" section. Purchase
and change another smoke
alarm device if the problem
still exist.
1. Press test button to pause
alarm.
2. Clean smoke alarm
device. Please refer to
the "maintenance and
cleaning" section.
3. Move smoke alarm
device to new location
and press test button.
1. Clean smoke alarm
device. Please refer to
the "maintenance and
cleaning" section.
2. If there are still failures
during warranty, you can
return to your retailer.
3. If the unit is out of
warranty, please replace
another new alarm.