- ページ 12

換気フード Whirlpool UXT4230AYWのPDF 取付説明書および取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT4230AYW 32 ページ。 30" (76.2 cm) and 36" (91.4 cm) range hood

ページを印刷する

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace grease filter

before operating hood.

Exterior Surfaces:

IMPORTANT: Do not use soap-filled scouring pads, abrasive

cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths

or paper towels.

To avoid damage to the stainless steel, do not use cleaners that

contain chlorine.

Cleaning Method:

Rub in direction of grain to avoid scratching or damaging the

surface.

For stainless steal models, Stainless Steel Cleaner and Polish

Part Number 31462A (not included): See "Assistance or

Service" section to order.

Liquid detergent or all-purpose cleaner:

Rinse with clean water and dry with soft, lint-free cloth.

Glass cleaner to remove fingerprints.

Metal Grease Filter

For vented installations:

1. Remove screw from the grease filter retainer.

2. Turn the grease filter retainer to release filter.

A. Filter retainer

3. Wash metal filters as needed in dishwasher or hot detergent

solution.

4. Reinstall the filter by placing the back edge in the channel at

rear of hood. Push filter into place, turn the filter retainer to

secure filter to range hood.

5. Replace screw in the grease filter retainer.

RANGE HOOD CARE

Cleaning

For non-vented (recirculating) installations:

The charcoal filter is not washable. It should last up to 6 months

with normal use.

1. Replace metal grease filter with a charcoal filter. For

To replace filter:

1. Remove screw from the grease filter retainer.

2. Turn the grease filter retainer to release filter.

3. Reinstall the filter by placing the back edge in the channel at

4. Replace screw in the grease filter retainer.

Replacing the Incandescent Light Bulb

Turn off the range hood and allow the light bulb to cool.

1. Disconnect power.

2. Squeeze the plastic lens cover and remove it from the hood.

3. Screw light bulb into socket.

4. Replace lens cover by squeezing cover and inserting tabs

5. Reconnect power.

If new light does not operate, make sure the lamp is inserted

correctly before calling service.

information on ordering, see the "Accessories" section.

rear of hood. Push filter into place, turn the filter retainer to

secure filter to range hood.

A. Light bulb socket

B. Lens cover

into slots.