- ページ 9

換気フード Whirlpool UXT4236AYWのPDF 取付説明書および取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT4236AYW 32 ページ。 30" (76.2 cm) and 36" (91.4 cm) range hood

ページを印刷する

Install Vent System

1. Install vent through the vent opening in upper cabinet or wall.

Complete venting system according to the selected venting

method. See "Venting Requirements" section.

2. Use caulking to seal exterior wall or roof opening around the

cap.

Install Range Hood

NOTE: Your model will have a 3¼" x 10" (8.3 x 25.4 cm)

rectangular vent damper on the inside of the range hood.

1. Remove the 3¼" x 10" (8.3 x 25.4 cm) rectangular vent

damper attached with 3.5 x 9.5 mm screws on the inside your

range hood. Use these screws to install the rectangular vent

damper.

A. 3 " x 10" (8.3 x 25.4 cm) rectangular vent damper

B. 3.5 x 9.5 mm screws

2. Lift the range hood up under cabinet and determine final

location by centering beneath cabinet. Mark on the underside

of cabinet the location of the 4 keyhole mounting slots on the

range hood. Set range hood aside on a covered surface.

A. Keyhole slot

3. Use

" (3 mm) drill bit and drill 4 pilot holes as shown.

A. Drill pilot hole.

4. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot

holes. Leave about

" (6.4 mm) space between screw heads

and cabinet to slide range hood into place.

(6.4 mm)

5. Remove vent knockouts depending on your installation

requirements.

A. Round vent knockout

B. Top rectangular vent knockout

C. Rear rectangular vent knockout

Round vent system installations - Remove top rectangular

and round vent knockouts.

Rectangular vent system installations - For roof

installations, remove the top rectangular vent knockout. For

wall installations, remove the rear rectangular vent knockout.

Non-vent (recirculating) installations - Do not remove any

knockouts.

6. Install 7" (17.8 cm) round vent mounting plate or 3¼" x 10"

(8.3 x 25.4 cm) vent damper, depending on your vent system

installation. Attach to range hood 3.5 x 9.5 mm screws

provided.

NOTE: The 7" (17.8 cm) round vent mounting plate is not

supplied. An optional 7" (17.8 cm) round damper is also

available as an accessory. For information on ordering, see

the "Accessories" section.

A. 7" (17.8 cm) Round damper (see "Accessories" section)

B. 3.5 x 9.5 mm screws

C. 7" (17.8 cm) round vent mounting plate. For information

on ordering, see the "Accessories" section.

D. Round vent knockout

E. Rectangular vent knockout