- ページ 10

換気フード Whirlpool (91.) BUILT-INのPDF 設置および使用マニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool (91.) BUILT-IN 24 ページ。 36" (91.4 cm) gas built-in cooktop
Whirlpool (91.) BUILT-IN にも：取付説明書 (16 ページ)

ページを印刷する

8. Using 2 people, lift range hood into final position, feeding

electrical wire through wiring opening. Position the range

hood so that the large end of the keyhole slots are over the

screws. Then push the hood toward the wall so that the

screws are in the neck of the slots. Tighten mounting screws

to cabinet, making sure mounting screws are in narrow neck

of slots.

9. Check that the damper, if used, rotates up and down freely.

10. For vented model installations only:

Connect ventwork to hood. Seal joints with clamps to make

secure and airtight.

Make Electrical Connection

WARNING

Fire Hazard

Electrically ground the blower.

Use copper wire.

Connect ground wire to green ground screw in

terminal box.

Failure to do so can result in death, fire, or

electrical shock.

Direct Wire Installation

1. Connect the white wire of the home power supply with the

white wire in the range hood using a UL listed twist-on

connector.

A. White wires

B. Black wires

C. Green ground screw

D. Ground wire

E. UL listed or CSA approved strain relief

2. Connect the black wire of the home power supply with the

black wire in the range hood using a UL listed twist-on

connector.

3. Connect ground wire (green or bare) of home power supply to

the green ground screw in the terminal box.

4. Tighten strain relief screws.

5. Install the terminal box cover.

6. Reconnect power.

Complete Installation

Install 75-watt (max.) incandescent light bulb.

1. Squeeze the plastic lens cover and remove it from the hood.

A. Light bulb socket

B. Lens cover

2. Screw light bulb into socket.

3. Replace lens cover by squeezing cover and inserting tabs

into slots.

Check Range Hood Operation

1. Check light operation only by pressing light button.

2. Check operation of fan by pressing button to Hi and Lo

positions.

3. If the range hood does not operate, check to see whether a

circuit breaker has tripped or a house fuse has blown.

NOTE: To get the most efficient use from your new range hood,

read the "Range Hood Use" section.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

The hood controls are located on the front right-hand side of the

range hood.

FAN

LIGHT

A. Fan control

B. Light control

Range Hood Controls

Operating the Light

Press light control to turn light on or off. Light may be turned off

or on anytime during range hood operation.

Operating the Fan

Press fan control to turn fan on and off and adjust fan speed.

Speed may be increased or decreased anytime during range

hood operation.